Difficulty

Easy

Steps

3

Time Required

                          15 - 30 minutes

Sections

1

  • Lip and Follower
  • 3 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackArmy Armament R32 1911 Airsoft GBB Pistol

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Performed on:

Army Armament R32-2 Sandstorm GBB Airsoft Pistol

What you need

Step 1

              Removing the old Lip and Follower.
  • Place the magazine on its side, with the release valve facing you.
  • Use a small bit and a hammer to carefully remove the two pins that hold the lip.
  • Be very careful and hold the magazine spring with your finger or something else, because when you remove the pins, everything may fly into oblivion.

Place the magazine on its side, with the release valve facing you.

Use a small bit and a hammer to carefully remove the two pins that hold the lip.

Be very careful and hold the magazine spring with your finger or something else, because when you remove the pins, everything may fly into oblivion.

1024

Step 2

              Replacing the rubber seal on the Lip.
  • Compare both old and new parts to ensure that they are the same. Here you can see my old ones on the left and the new ones on the right.
  • Carefully push down on the rubber seal to remove it and put it on the new Lip.

Compare both old and new parts to ensure that they are the same. Here you can see my old ones on the left and the new ones on the right.

Carefully push down on the rubber seal to remove it and put it on the new Lip.

Step 3

              Reassembly.
  • The magazine Follower should be put with the notch facing you.
  • The proper order of reassembly is the following, from botton to top:
  • Magazine -> Spring -> Follower -> Lip -> Pins

The magazine Follower should be put with the notch facing you.

The proper order of reassembly is the following, from botton to top:

Magazine -> Spring -> Follower -> Lip -> Pins

Be careful when working with springs, as they can eject things into space.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                    Simeon Brankov

Member since: 11/08/2020

3,455 Reputation

                                      41 Guides authored                  



                       Badges:
                       17







                                                        +14 more badges