Difficulty

Moderate

Steps

6

Time Required

                          25 - 30 minutes

Sections

1

  • Speaker
  • 6 steps

Flags

0

  • BackCD Player

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Before proceeding to follow this guide, make sure that it is truly an internal speaker problem. For instance, check the power source of the radio and whether or not the batteries are too weak or dead. If it uses a power cord, make sure to check if it’s damaged in any way.

In addition, if you have checked the power sources, be sure to disconnect it before attempting to disassemble the radio.

What you need

Step 1

              Speaker
  • Remove the batteries located under the radio by sliding open the removable panel.

Remove the batteries located under the radio by sliding open the removable panel.

1024

Step 2

  • Use a six inch Phillips #2 screwdriver to remove the screws that hold the clamshell body together.
  • There will be six (6) screws at the bottom of the speaker, one (1) screw in the CD player, and two (2) under the battery panel. A total of nine (9) screws.
  • Each screw is 12.7 millimeters.

Use a six inch Phillips #2 screwdriver to remove the screws that hold the clamshell body together.

There will be six (6) screws at the bottom of the speaker, one (1) screw in the CD player, and two (2) under the battery panel. A total of nine (9) screws.

Each screw is 12.7 millimeters.

Step 3

  • Use the plastic spudger or the Jimmy to gently pry open the plastic shell halves from each other.
  • The red boxes highlight the speakers you are replacing.
  • Be careful of loose wiring when prying the halves open.

Use the plastic spudger or the Jimmy to gently pry open the plastic shell halves from each other.

The red boxes highlight the speakers you are replacing.

Be careful of loose wiring when prying the halves open.

Step 4

  • Unplug the small red connector from the circuit board.
  • Be firm with your pinch and pull gently.

Unplug the small red connector from the circuit board.

Be firm with your pinch and pull gently.

Step 5

  • Carefully remove the speakers from their placeholders by lifting each speaker up.
  • Set removed speakers aside and recycle them later.

Carefully remove the speakers from their placeholders by lifting each speaker up.

Set removed speakers aside and recycle them later.

Step 6

  • Insert new speakers where the old ones were located
  • Then connect the new speakers to the circuit board.

Insert new speakers where the old ones were located

Then connect the new speakers to the circuit board.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 4 other contributors 


                    Charlotte Kong

Member since: 09/30/2019

148 Reputation

                                      1 Guide authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       CSU Fullerton, Team S1-G2, Bruce Fall 2019                        

                                                  Member of CSU Fullerton, Team S1-G2, Bruce Fall 2019 



                    CSUF-BRUCE-F19S1G2                     


                                            4 Members                     


                                            1 Guide authored