Difficulty

Moderate

Steps

8

Time Required

                          10 minutes

Sections

3

  • Battery
  • 2 steps
  • Front Panel
  • 2 steps
  • Button
  • 4 steps

Flags

0

  • BackAkaso EK7000 4K

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Locate the battery cover at the bottom of the camera. Use your fingers to gently pry open the battery cover.

Locate the battery cover at the bottom of the camera. Use your fingers to gently pry open the battery cover.

1024

Step 2

  • Locate the small plastic flap attached to the battery. Pull the battery out towards you.

Locate the small plastic flap attached to the battery. Pull the battery out towards you.

Step 3

              Front Panel
  • Using the metal spudger, gently pry open the front panel from the exposed battery cartridge.

Using the metal spudger, gently pry open the front panel from the exposed battery cartridge.

Step 4

  • Remove the rest of front panel with your fingers or with assistance from the spudger.

Remove the rest of front panel with your fingers or with assistance from the spudger.

Step 5

              Button
  • Using a Phillips #000 screwdriver, remove the four screws securing the cover plate.

Using a Phillips #000 screwdriver, remove the four screws securing the cover plate.

Step 6

  • Using your thumb or a spudger, gently push up from inside the battery cartridge.
  • Gently lift the cover plate until you can see into the inside of the camera. The cover will not completely come off, so be careful not to damage any of the inner wiring.

Using your thumb or a spudger, gently push up from inside the battery cartridge.

Gently lift the cover plate until you can see into the inside of the camera. The cover will not completely come off, so be careful not to damage any of the inner wiring.

Step 7

  • Using the metal spudger, push down on the up and down button as shown in the picture. Dislodge the button and it should fall to the bottom of the camera.

Using the metal spudger, push down on the up and down button as shown in the picture. Dislodge the button and it should fall to the bottom of the camera.

Step 8

  • Again, using the metal spudger, gently pull out the button from within the camera.

Again, using the metal spudger, gently pull out the button from within the camera.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 1 other contributor 


                    Annie Sun

Member since: 02/05/2019

436 Reputation

                                      3 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       UC Davis, Team S20-G2, Lore Winter 2019                        

                                                  Member of UC Davis, Team S20-G2, Lore Winter 2019 



                    UCD-LORE-W19S20G2                     


                                            3 Members                     


                                            4 Guides authored

ecab110544 - Jun 18, 2020

Reply

Annie, where do I get the replacemnet bottons for the Akaso 7000 pro?

Mark - Sep 9, 2020

Reply

I need a replacement top button. Plastic got messed up but was able to still press the metallic part. But didn’t realize it wasn’t secure and it fell off at some point. Can start recording by shorting across contacts but looking for a fix.

luis - Oct 2, 2020

Reply

Who is going to answer above questions?