Difficulty
Difficult
Steps
5
Time Required
15 - 20 minutes
Sections
1
- Battery
- 5 steps
Flags
Markup Mishap
This guide needs better markups. Help out by correcting or making some markup annotations.
BackAKASO KingPad A90
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Remove screws.
- Insert spudger tool on the middle of the left side, between the white and black plastic.
- Slide in a plastic opening tool and use it to further pull the back off.
- Work your way around the edge of the tablet with the plastic opening tool and insert more as needed.
- Pull off the back cover.
Remove screws.
Insert spudger tool on the middle of the left side, between the white and black plastic.
Slide in a plastic opening tool and use it to further pull the back off.
Work your way around the edge of the tablet with the plastic opening tool and insert more as needed.
Pull off the back cover.
1024
Step 2
- Using the black plastic spudger tool, insert it under a corner of the battery.
- Work your way around the edges to pry the battery and loosen it from the adhesive.
- Remove the battery.
Using the black plastic spudger tool, insert it under a corner of the battery.
Work your way around the edges to pry the battery and loosen it from the adhesive.
Remove the battery.
Step 3
- Locate the battery unit solder points and note where it is attached to the motherboard.
- Plug in your soldering iron/pen and wait the required amount of time to heat up.
- Be careful with the iron as the tip is very hot and it could burn you or the tablet
- Apply a small amount of pressure with the iron on the solder points until the joints come loose and the wires move freely away from the board
- Remove the battery unit
Locate the battery unit solder points and note where it is attached to the motherboard.
Plug in your soldering iron/pen and wait the required amount of time to heat up.
Be careful with the iron as the tip is very hot and it could burn you or the tablet
Apply a small amount of pressure with the iron on the solder points until the joints come loose and the wires move freely away from the board
Remove the battery unit
Step 4
- Locate the red and black wire ends of your new battery
- Take your solder out and place it on the point with the wire
- Use the iron/pen to slowly melt a small piece of solder onto the point and let it solidify.
- Be careful not to use too much solder as a large blob could result in a short on your device
- Repeat this step for the other point
Locate the red and black wire ends of your new battery
Take your solder out and place it on the point with the wire
Use the iron/pen to slowly melt a small piece of solder onto the point and let it solidify.
Be careful not to use too much solder as a large blob could result in a short on your device
Repeat this step for the other point
Step 5
- Replace the back cover with the new part in place.
- Gently press the speaker into place.
- Don’t let the volume rocker unit fall out of place.
- Replace the screws.
Replace the back cover with the new part in place.
Gently press the speaker into place.
Don’t let the volume rocker unit fall out of place.
Replace the screws.
Cancel: I did not complete this guide.
5 other people completed this guide.
Author
with 3 other contributors
Daniel Garcia
Member since: 03/24/2015
179 Reputation
2 Guides authored
Badges:
9
+6 more badges
Team
UMass Dartmouth, Team 4-6, Vijaybhaskar Spring 2015
Member of UMass Dartmouth, Team 4-6, Vijaybhaskar Spring 2015
UMASSD-VIJAYBHASKAR-S15S4G6
3 Members
6 Guides authored
