Akaso Kingpad A90 Rear Speaker Replacement Repair Guide

Difficulty

Difficult

Steps

4

Time Required

                          15 - 20 minutes            

Sections

1

• Rear Speaker
• 4 steps

Flags

Markup Mishap

This guide needs better markups. Help out by correcting or making some markup annotations.

• BackAKASO KingPad A90

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Rear Speaker               

• Remove screws.
• Insert spudger tool on the middle of the left side, between the white and black plastic.
• Slide in a plastic opening tool and use it to further pull the back off.
• Work your way around the edge of the tablet with the plastic opening tool and insert more as needed.
• Pull off the back cover.

Remove screws.

Insert spudger tool on the middle of the left side, between the white and black plastic.

Slide in a plastic opening tool and use it to further pull the back off.

Work your way around the edge of the tablet with the plastic opening tool and insert more as needed.

Pull off the back cover.

1024

Step 2

• Plug in soldering iron and let it warm up for ten minutes.
• Locate the speaker solder points and note where it is attached to the motherboard.
• Solder the old speaker out of its mark. (Touch the tip of the solder iron to the soldering point).

Plug in soldering iron and let it warm up for ten minutes.

Locate the speaker solder points and note where it is attached to the motherboard.

Solder the old speaker out of its mark. (Touch the tip of the solder iron to the soldering point).

Step 3

• Solder the new speaker onto the points where the old speaker was.

Solder the new speaker onto the points where the old speaker was.

Step 4

• Replace the back cover with the new rear speaker unit in place.
• Gently press the speaker into place.
• Don’t let the volume rocker unit fall out of place.
• Replace the screws.

Replace the back cover with the new rear speaker unit in place.

Gently press the speaker into place.

Don’t let the volume rocker unit fall out of place.

Replace the screws.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    camchristo                     

Member since: 03/24/2015

68 Reputation

                                      1 Guide authored                  



                       Badges:
                       7







                                                        +4 more badges                           

Team

                       UMass Dartmouth, Team 4-6, Vijaybhaskar Spring 2015                        

                                                  Member of UMass Dartmouth, Team 4-6, Vijaybhaskar Spring 2015 



                    UMASSD-VIJAYBHASKAR-S15S4G6                     


                                            3 Members                     


                                            6 Guides authored