Difficulty

Difficult

Steps

7

Time Required

                          20 minutes

Sections

2

  • Battery
  • 4 steps
  • Motherboard
  • 3 steps

Flags

0

  • BackAlcatel Jitterbug Smart

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

It’s also an useful guide to help you to replace headphone Jack, camera and charging port.

What you need

Step 1

              Battery
  • Pry back cover open with a medal spudger, or your fingernail, in the divot at the bottom left corner of the phone.
  • Lift open case by the corner nearest the divot and remove it from the phone.

Pry back cover open with a medal spudger, or your fingernail, in the divot at the bottom left corner of the phone.

Lift open case by the corner nearest the divot and remove it from the phone.

1024

Step 2

  • Remove 13 1mm JIS screws with JIS #000 Screwdriver.

Remove 13 1mm JIS screws with JIS #000 Screwdriver.

Step 3

  • Gently pry off the Mid frame from the phone using a Metal Spudger.

Gently pry off the Mid frame from the phone using a Metal Spudger.

Step 4

  • Use a pair of tweezers to pull the battery connector from its port.
  • Be careful not to tear the battery from its connection.

Use a pair of tweezers to pull the battery connector from its port.

Be careful not to tear the battery from its connection.

Step 5

              Motherboard
  • Use the Plastic Opening tools to gently dislodge the two connection on the top and bottom right of the phone from the inside of the phone.

Use the Plastic Opening tools to gently dislodge the two connection on the top and bottom right of the phone from the inside of the phone.

Step 6

  • Use a pair of tweezers to pull the black ribbon connector from its port.
  • Use a metal Spudger to gentle remove the speaker that glued at the bottom left of the phone.
  • Be careful to avoid damage the black connector or the wire connect the speaker to motherboard.

Use a pair of tweezers to pull the black ribbon connector from its port.

Use a metal Spudger to gentle remove the speaker that glued at the bottom left of the phone.

Be careful to avoid damage the black connector or the wire connect the speaker to motherboard.

Step 7

  • Using a plastic opening tool, begin to gently pry the motherboard, away from the display assembly.
  • The motherboard will freely remove.

Using a plastic opening tool, begin to gently pry the motherboard, away from the display assembly.

The motherboard will freely remove.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Gavin Le

Member since: 02/13/2018

469 Reputation

                                      3 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges

Team

                       USF Tampa, Team S11-G4, Cheng Spring 2018                        

                                                  Member of USF Tampa, Team S11-G4, Cheng Spring 2018 



                    USFT-CHENG-S18S11G4                     


                                            4 Members                     


                                            10 Guides authored