Difficulty
Moderate
Steps
5
Time Required
7 - 15 minutes
Sections
2
- Back Cover
- 2 steps
- Microphone
- 3 steps
Flags
1
Needs More Images
A few more images would make this guide’s procedures crystal clear.
BackAlcatel One Touch Pop 7
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Cover
- Begin by opening SD port cover as this is the best location to start prying.
Begin by opening SD port cover as this is the best location to start prying.
1024
Step 2
- Use the plastic opening tool to pry around the edges of the back cover until it pops off.
Use the plastic opening tool to pry around the edges of the back cover until it pops off.
Step 3
Microphone
- Disconnect battery by pulling up on the ZIF connector with precision tweezers for safety.
Disconnect battery by pulling up on the ZIF connector with precision tweezers for safety.
Step 4
- Remove the Microphone from it’s slot with the precision tweezers.
Remove the Microphone from it’s slot with the precision tweezers.
Step 5
- Solder the wires off of the motherboard with a soldering iron while holding the wires with the precision tweezers. For information on how to solder safely and correctly go to this link: How To Solder and Desolder Connections
Solder the wires off of the motherboard with a soldering iron while holding the wires with the precision tweezers. For information on how to solder safely and correctly go to this link: How To Solder and Desolder Connections
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Philip Schenck
Member since: 03/20/2018
181 Reputation
2 Guides authored
Badges:
3
Team
IUPUI, Team S6-G2, Baechle Spring 2018
Member of IUPUI, Team S6-G2, Baechle Spring 2018
IUPUI-BAECHLE-S18S6G2
3 Members
8 Guides authored