Difficulty

Moderate

Steps

10

Time Required

                          30 minutes

Sections

1

  • Charging Port
  • 10 steps

Flags

0

  • BackAlcatel Pop 4 Plus

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Please use extreme caution when handling a Soldering tool. Tool will produce extreme heats.

If your phone is not charging correctly or you notice that your charger slides in and out without staying in, you may need to replace your charging port.

For more information on soldering connections, please read the How to Solder and Desolder Connections guide.

What you need

Step 1

              Charging Port
  • Begin by removing the back of the phone. Press your nail or a thin object in the bottom right-hand corner of the phone and gently press to release the back of the phone from the front.

Begin by removing the back of the phone. Press your nail or a thin object in the bottom right-hand corner of the phone and gently press to release the back of the phone from the front.

1024

Step 2

  • Remove seventeen 1.2 mm screws from the phone’s mid-frame using the Phillips #000 screwdriver.

Remove seventeen 1.2 mm screws from the phone’s mid-frame using the Phillips #000 screwdriver.

Step 3

  • Once the screws have been taken out, remove the mid-frame protecting the phone’s electronics by using a fingernail or tool to pry it off.

Once the screws have been taken out, remove the mid-frame protecting the phone’s electronics by using a fingernail or tool to pry it off.

Step 4

  • Disconnect the battery from the motherboard and remove it.

Disconnect the battery from the motherboard and remove it.

Step 5

  • Unhook the USB ribbon from the motherboard.

Unhook the USB ribbon from the motherboard.

Step 6

  • Disconnect the phone’s ribbon cable.

Disconnect the phone’s ribbon cable.

Step 7

  • Disconnect the ribbon cable from the phone

Disconnect the ribbon cable from the phone

Step 8

  • Remove the phone’s rear camera from the motherboard.

Remove the phone’s rear camera from the motherboard.

Step 9

  • Use the flat end of the spudger to pry off the motherboard.

Use the flat end of the spudger to pry off the motherboard.

Step 10

  • On the charging port, heat the four connection points with Soldering tool and remove from prongs.
  • For more information on soldering, please visit the How to Solder and Desolder Connections guide.

On the charging port, heat the four connection points with Soldering tool and remove from prongs.

For more information on soldering, please visit the How to Solder and Desolder Connections guide.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors 


                    Anna Gongre

Member since: 09/20/2019

319 Reputation

                                      2 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       University of North Alabama, Team S1-G5, Winner Fall 2019                        

                                                  Member of University of North Alabama, Team S1-G5, Winner Fall 2019 



                    UNA-WINNER-F19S1G5                     


                                            3 Members                     


                                            6 Guides authored

Carlos Reboredo - Jan 20, 2020

Reply

Hello, nice to meet you. I like your guide because it is didactic and objective in the apprehension process. I would like to support me in the visualization to buy the charging port. Alcatel pop 4 plus 5056e. Thank you