Difficulty

Moderate

Steps

8

Time Required

                          30 minutes

Sections

1

  • Touch Screen Glass Digitizer
  • 8 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackAlcatel POP C9 OT7047

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Video Overview

Step 1

              Battery Cover Removal
  • The Battery / Back cover is secured to the main frame by plastic clips.
  • Use a plastic tool to remove it.

The Battery / Back cover is secured to the main frame by plastic clips.

Use a plastic tool to remove it.

1024

Step 2

              Battery Disconnecting 1
  • Use a Phillips screwdriver and remove the two screws secured the battery connector shield.
  • With tweezers careful remove the battery connector shield.

Use a Phillips screwdriver and remove the two screws secured the battery connector shield.

With tweezers careful remove the battery connector shield.

Step 3

              Battery Disconnecting 2
  • Disconnect the battery cable.

Disconnect the battery cable.

Step 4

              Main Board removal 1
  • Disconnect:
  • Touchscreen flex cable
  • Main Camera flex cable
  • LCD flex cable
  • Vibra-motor
  • New line.Remove 7x Phillips screws.

Disconnect:

Touchscreen flex cable

Main Camera flex cable

LCD flex cable

Vibra-motor

New line.Remove 7x Phillips screws.

Step 5

  • Careful unstuck the Volume buttons flex cable and the Power button flex cable.
  • Use a plastic tool and remove the Logic board.

Careful unstuck the Volume buttons flex cable and the Power button flex cable.

Use a plastic tool and remove the Logic board.

Step 6

              Touch screen glass removal
  • Use a hair dryer to warm the glass to soften the adhesive.
  • Use a knife or tool with a sharp edge and start the separating the glass from the frame.
  • Continue with a plastic tool.

Use a hair dryer to warm the glass to soften the adhesive.

Use a knife or tool with a sharp edge and start the separating the glass from the frame.

Continue with a plastic tool.

Step 7

  • Insert wisdom here.

Insert wisdom here.

Step 8

  • Clean the frame and install a new adhesive tape.
  • Install the touch screen.

Clean the frame and install a new adhesive tape.

Install the touch screen.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    ZFix

Member since: 12/09/2013

187,195 Reputation

                                      330 Guides authored                  



                       Badges:
                       35







                                                        +32 more badges

Team

                       Master Techs                        

                                                  Member of Master Techs 



                    Community                     


                                            310 Members                     


                                            1,168 Guides authored