Difficulty

Easy

Steps

5

Time Required

                          30 minutes

Sections

1

  • Battery
  • 5 steps

Flags

2

In Progress

This guide is a work in progress. Reload periodically to see the latest changes!

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackTransActive Mobile

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Step 1

              Remove the metal protectors
  • Loosen the three Allen key screws holding the metal corner protectors. Only remove the screws on the front of the amp.

Loosen the three Allen key screws holding the metal corner protectors. Only remove the screws on the front of the amp.

1024

Step 2

              Remove the frontal angled metal strips
  • Once the corner protectors have been removed, the angled metal strips that protect the edges of the front can be removed. Remove the side, top and bottom protections.

Once the corner protectors have been removed, the angled metal strips that protect the edges of the front can be removed. Remove the side, top and bottom protections.

Step 3

              Remove the front control panel
  • Loosen and remove the 8 screws that hold the front control panel for the microphone and guitar inputs, RCA connector, and volume control.

Loosen and remove the 8 screws that hold the front control panel for the microphone and guitar inputs, RCA connector, and volume control.

Step 4

              Remove the speaker
  • Loosen and remove the four woofer retaining screws. Hold the speaker carefully to avoid damaging the membrane and to prevent it from falling to the ground once the screws have been removed. Move it to the left, taking note of the length of the cable connected to its pins so you do not jerk out the cable.

Loosen and remove the four woofer retaining screws. Hold the speaker carefully to avoid damaging the membrane and to prevent it from falling to the ground once the screws have been removed. Move it to the left, taking note of the length of the cable connected to its pins so you do not jerk out the cable.

Step 5

              Remove and disconnect the battery
  • Loosen and remove the 4 screws from the wooden panel that forms part of the compartment where the battery is fitted.
  • Remove the panel once the screws have been removed.
  • Move the battery outwards, to access the positive (red) and negative (black) terminals and then disconnect them. Once disconnected, completely remove the battery and replace it with the new one.

Loosen and remove the 4 screws from the wooden panel that forms part of the compartment where the battery is fitted.

Remove the panel once the screws have been removed.

Move the battery outwards, to access the positive (red) and negative (black) terminals and then disconnect them. Once disconnected, completely remove the battery and replace it with the new one.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

        These translators are helping us fix the world!      Want to contribute?      Start translating ›

Special thanks to these translators:

100%

Christopher Sean Harris

Alessandro Cassinari

DeZom

Author

                                      with 1 other contributor 


                    Agustín Ramírez

Member since: 05/11/2020

121 Reputation

                                      1 Guide authored                  



                       Badges:
                       1