Alienware 17 R4 Hard Disk Drive Hdd Replacement Repair Guide

Difficulty

Moderate

Steps

6

Time Required

                          15 minutes            

Sections

2

• Base Cover
• 2 steps
• Hard Disk Drive (HDD)
• 4 steps

Flags

0

• BackAlienware 17 R4

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Base Cover               

• Use a PH1 screwdriver bit to remove the six M2.5x13 screws (2.4 mm) on the back of the laptop.
• Use a PH1 screwdriver bit to loosen the one M2x3 screw (1.9 mm).
• The M2x3 screw (1.9 mm) does not come out completely.

Use a PH1 screwdriver bit to remove the six M2.5x13 screws (2.4 mm) on the back of the laptop.

Use a PH1 screwdriver bit to loosen the one M2x3 screw (1.9 mm).

The M2x3 screw (1.9 mm) does not come out completely.

1024

Step 2

• Pull the base cover up to remove it.
• If you are having trouble, insert a plastic opening tool into the divots along the laptop’s edges to loosen.
• Removing the cover may require some force.

Pull the base cover up to remove it.

If you are having trouble, insert a plastic opening tool into the divots along the laptop’s edges to loosen.

Removing the cover may require some force.

Step 3

              Hard Disk Drive (HDD)               

• Disconnect the battery connector cable, located on the right side of the laptop, above the hard disk drive.
• Once you have removed the cable, wait 5-10 minutes to allow the laptop to power down.
• Failure to remove the battery connector cable properly may damage other parts of the laptop.

Disconnect the battery connector cable, located on the right side of the laptop, above the hard disk drive.

Once you have removed the cable, wait 5-10 minutes to allow the laptop to power down.

Failure to remove the battery connector cable properly may damage other parts of the laptop.

Step 4

• Use a PH1 screwdriver bit to remove the four M2.5x5 screws (2.4 mm) on the hard disk drive.

Use a PH1 screwdriver bit to remove the four M2.5x5 screws (2.4 mm) on the hard disk drive.

Step 5

• Gently lift the HDD cable to disconnect it from the laptop.

Gently lift the HDD cable to disconnect it from the laptop.

Step 6

• Pull the hard drive up to remove.

Pull the hard drive up to remove.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 5 other contributors 

                    Hector Mendez III                     

Member since: 09/11/2017

1,216 Reputation

                                      8 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges                           

Team

                       CSU Fullerton, Team S2-G4, Bruce Fall 2017                        

                                                  Member of CSU Fullerton, Team S2-G4, Bruce Fall 2017 



                    CSUF-BRUCE-F17S2G4                     


                                            4 Members                     


                                            9 Guides authored