Difficulty
Moderate
Steps
3
Time Required
20 minutes
Sections
1
- Circuit Board
- 3 steps
Flags
0
BackAlpine MRV-M500
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Circuit Board
- Remove all the Phillips 10.0mm and 7.0mm screws on the outside of the case.
Remove all the Phillips 10.0mm and 7.0mm screws on the outside of the case.
1024
Step 2
- Remove all Phillips 7.5mm, 12.5mm, and 10.5mm screws holding the circuit board to the case.
- Make sure the device has been powered off and disconnected from the power source for at least a day before touching the electronic components.
Remove all Phillips 7.5mm, 12.5mm, and 10.5mm screws holding the circuit board to the case.
Make sure the device has been powered off and disconnected from the power source for at least a day before touching the electronic components.
Step 3
- Remove the circuit board from the case.
Remove the circuit board from the case.
To reassemble your device, follow these instructions in reverse order using the replacement circuit board.
Cancel: I did not complete this guide.
4 other people completed this guide.
Author
with 4 other contributors
Eric Gaulke
Member since: 09/17/2018
623 Reputation
3 Guides authored
Badges:
9
+6 more badges
Team
Washington State, Team S2-G6, Hope Fall 2018
Member of Washington State, Team S2-G6, Hope Fall 2018
WSU-HOPE-F18S2G6
4 Members
6 Guides authored
