Difficulty
Moderate
Steps
8
Time Required
20 minutes
Sections
2
- Altec Lansing BoomJacket 2 Disassembly
- 6 steps
- Speaker
- 2 steps
Flags
1
Needs More Images
A few more images would make this guide’s procedures crystal clear.
BackAltec Lansing BoomJacket 2
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Altec Lansing BoomJacket 2 Disassembly
- Starting from any side, use your fingers to grab the black rubber sleeve and gently pull away from the speaker on both sides.
Starting from any side, use your fingers to grab the black rubber sleeve and gently pull away from the speaker on both sides.
1024
Step 2
- Using your fingers, grab the blue sleeve from one side and pull away from the unit.
Using your fingers, grab the blue sleeve from one side and pull away from the unit.
Step 3
- At each of the marked pry spots, use the metal spudger to lift the speaker grill away from the case.
- Avoid using excessive force to prevent bending the grill.
At each of the marked pry spots, use the metal spudger to lift the speaker grill away from the case.
Avoid using excessive force to prevent bending the grill.
Step 4
- Use the tweezers to remove the six rubber stoppers. There are four in the middle and two on the sides.
Use the tweezers to remove the six rubber stoppers. There are four in the middle and two on the sides.
Step 5
- Use the PH1 Phillips screwdriver to remove the six 12mm screws that lie underneath each rubber stopper.
Use the PH1 Phillips screwdriver to remove the six 12mm screws that lie underneath each rubber stopper.
Step 6
- Gently pull apart the front panel from the base of the speaker.
Gently pull apart the front panel from the base of the speaker.
Step 7
Speaker
- Unscrew the four screws holding the speaker in place.
Unscrew the four screws holding the speaker in place.
Step 8
- Unscrew the two screws on the smaller speaker.
- Pull the small speaker through the larger speaker hole.
Unscrew the two screws on the smaller speaker.
Pull the small speaker through the larger speaker hole.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Zach Braaten
Member since: 07/12/2018
516 Reputation
4 Guides authored
Badges:
8
+5 more badges
Team
UW Tacoma, Team S1-G4, Cardinal Summer 2018
Member of UW Tacoma, Team S1-G4, Cardinal Summer 2018
UWT-CARDINAL-SU18S1G4
4 Members
4 Guides authored
