Difficulty

Moderate

Steps

7

Time Required

                          10 - 15 minutes

Sections

2

  • External Panels
  • 4 steps
  • Speaker Head
  • 3 steps

Flags

0

  • BackAltec Lansing VersA Smart

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              External Panels
  • Remove external rubber cover.

Remove external rubber cover.

1024

Step 2

  • Use blue plastic opening tool to remove the external speaker face by placing it in the slight opening at the bottom.
  • Use a lever motion, push the tool down, lifting the speaker face.
  • Use fingers to grip and remove speaker face.
  • Repeat on reverse side to remove the second speaker face.

Use blue plastic opening tool to remove the external speaker face by placing it in the slight opening at the bottom.

Use a lever motion, push the tool down, lifting the speaker face.

Use fingers to grip and remove speaker face.

Repeat on reverse side to remove the second speaker face.

Step 3

  • Orient speaker so volume buttons are facing away from you, and Bluetooth and power buttons are on the left-hand side.
  • Remove the seven 14mm screws using the Phillips #1 screwdriver.

Orient speaker so volume buttons are facing away from you, and Bluetooth and power buttons are on the left-hand side.

Remove the seven 14mm screws using the Phillips #1 screwdriver.

Step 4

  • Reorient speaker so Bluetooth and power buttons are now on the right-hand side.
  • Separate the two panels along the crease.
  • Blue plastic opening tool may be needed to separate panels.
  • Remove the panel with no buttons to expose internal area of the device.
  • Motherboard and all internal components are under this panel.

Reorient speaker so Bluetooth and power buttons are now on the right-hand side.

Separate the two panels along the crease.

Blue plastic opening tool may be needed to separate panels.

Remove the panel with no buttons to expose internal area of the device.

Motherboard and all internal components are under this panel.

Step 5

              Speaker Head
  • Detach the two wire connections from the motherboard.
  • Remove the speaker bed from the internal cavity of the device.

Detach the two wire connections from the motherboard.

Remove the speaker bed from the internal cavity of the device.

Step 6

  • Orient speaker bed so the speaker heads are facing up.
  • Remove the two 14mm screws using the Phillips #1 screwdriver.

Orient speaker bed so the speaker heads are facing up.

Remove the two 14mm screws using the Phillips #1 screwdriver.

Step 7

  • Separate the two plastic pieces of the speaker bed.
  • Flip the top plastic piece so the speaker heads are face down.
  • Speaker heads may fall out on their own.
  • Remove the two speaker heads.

Separate the two plastic pieces of the speaker bed.

Flip the top plastic piece so the speaker heads are face down.

Speaker heads may fall out on their own.

Remove the two speaker heads.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Rachael Hopp

Member since: 09/10/2018

550 Reputation

                                      5 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges

Team

                       University of Alabama, Team S1-G3, Bedsole Fall 2018                        

                                                  Member of University of Alabama, Team S1-G3, Bedsole Fall 2018 



                    UA-BEDSOLE-F18S1G3                     


                                            3 Members                     


                                            6 Guides authored