Aluratek Admpf310F Remote Sensor Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          10 - 15 minutes

Sections

Screen
4 steps
Remote Sensor
2 steps

Flags

BackAluratek ADMPF310F
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Screen

Using the plastic opening tool, pry off the clips all around the frame. You will hear a popping sound for every clip
Be sure not to pry to hard because you could crack or break the plastic facing of the device.

Using the plastic opening tool, pry off the clips all around the frame. You will hear a popping sound for every clip

Be sure not to pry to hard because you could crack or break the plastic facing of the device.

1024

Step 2

Lift screen out of place so you can access the plugs that connect it.
Be careful not to pull the screen to far away when placing to the side, many fragile wires are connected.

Lift screen out of place so you can access the plugs that connect it.

Be careful not to pull the screen to far away when placing to the side, many fragile wires are connected.

Step 3

Using the plastic spudger tool lift the plastic zif(zero instertion force) connector clip up.
Pull the ribbon cable away from the motherboard.
Be careful as this clip is very frail.

Using the plastic spudger tool lift the plastic zif(zero instertion force) connector clip up.

Pull the ribbon cable away from the motherboard.

Be careful as this clip is very frail.

Step 4

Disconnect the red and black cable connecting the screen to the motherboard by just pulling it out.

Disconnect the red and black cable connecting the screen to the motherboard by just pulling it out.

Step 5

              Remote Sensor

Pull out the remote sensor from its holder with your hands.
Unsolder the remote sensor from the motherboard.

Pull out the remote sensor from its holder with your hands.

Unsolder the remote sensor from the motherboard.

Step 6

Resolder the the remote sensor back to the motherboard.
For more on how to solder check the link here.

Resolder the the remote sensor back to the motherboard.

For more on how to solder check the link here.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors

                    Pascal Alexis

Member since: 11/05/2015

427 Reputation

                                      3 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       UMass Dartmouth, Team 5-1, Martin Fall 2016                        

                                                  Member of UMass Dartmouth, Team 5-1, Martin Fall 2016 



                    UMASSD-MARTIN-F16S5G1                     


                                            3 Members                     


                                            5 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team