Difficulty

Moderate

Steps

9

Time Required

                          20 - 30 minutes

Sections

2

  • Motherboard
  • 8 steps
  • USB Port
  • 1 step

Flags

0

  • BackAluratek ADMPF310F

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Motherboard
  • Using the black nylon spudger, pry off the clips all around the frame. You will hear a popping sound for every clip
  • Be sure not to pry to hard because you could crack or break the plastic facing of the device.

Using the black nylon spudger, pry off the clips all around the frame. You will hear a popping sound for every clip

Be sure not to pry to hard because you could crack or break the plastic facing of the device.

1024

Step 2

  • Lift screen out of place so you can access the plugs that connect it.

Lift screen out of place so you can access the plugs that connect it.

Step 3

  • Using the plastic spudger tool lift the plastic zif(zero instertion force) connector clip up.
  • Pull the ribbon cable away from the mother board.
  • Be careful as this zif connector is very frail plastic.

Using the plastic spudger tool lift the plastic zif(zero instertion force) connector clip up.

Pull the ribbon cable away from the mother board.

Be careful as this zif connector is very frail plastic.

Step 4

  • Disconnect the red and black cable connecting the screen to the motherboard by just pulling it out.

Disconnect the red and black cable connecting the screen to the motherboard by just pulling it out.

Step 5

  • Pull out remote receiver out of its clip.
  • Be careful to not move the wires around for the remote receiver too much, as they are soldered to the motherboard.

Pull out remote receiver out of its clip.

Be careful to not move the wires around for the remote receiver too much, as they are soldered to the motherboard.

Step 6

  • Using fingers pull the first speaker wire that is located closest to the speakers
  • Again using your fingers, pull out the second speaker wire near the far side of the motherboard.

Using fingers pull the first speaker wire that is located closest to the speakers

Again using your fingers, pull out the second speaker wire near the far side of the motherboard.

Step 7

  • Using the ph0 phillips head screwdriver unscrew the four 4mm screws circled in the picture.

Using the ph0 phillips head screwdriver unscrew the four 4mm screws circled in the picture.

Step 8

  • Pull up the smaller end of the motherboard.
  • Apply force pulling away from the USB ports to get the mother board out of place.

Pull up the smaller end of the motherboard.

Apply force pulling away from the USB ports to get the mother board out of place.

Step 9

              USB Port
  • On the back end of the mother board unsolder the USB port at the two points shown.

On the back end of the mother board unsolder the USB port at the two points shown.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Pascal Alexis

Member since: 11/05/2015

427 Reputation

                                      3 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       UMass Dartmouth, Team 5-1, Martin Fall 2016                        

                                                  Member of UMass Dartmouth, Team 5-1, Martin Fall 2016 



                    UMASSD-MARTIN-F16S5G1                     


                                            3 Members                     


                                            5 Guides authored