Amazon Echo 2Nd Generation Speaker Replacement Repair Guide

Difficulty

Moderate

Steps

5

Time Required

                          6 minutes            

Sections

2

• AMP Board
• 3 steps
• Subwoofer (speaker)
• 2 steps

Flags

0

• History
• Save to Favorites
• Download PDF
• Edit
• Translate
• Get Shareable Link
• Embed This Guide
• Notify Me of Changes
• Stop Notifications

Introduction

What you need

Step 1

              AMP Board               

• Remove the rubber layer beneath the device.
• Look for the crater beneath the rubber layer and place your thumb on it. Hold down and lift off the cover with your other hand.
• Remove the four 8.0 mm T8 Torx screws on the lid.
• Remove the lid from the device.

Remove the rubber layer beneath the device.

Look for the crater beneath the rubber layer and place your thumb on it. Hold down and lift off the cover with your other hand.

Remove the four 8.0 mm T8 Torx screws on the lid.

Remove the lid from the device.

1024

Step 2

• Use a spudger to flip up the small flap on the ZIF connector.
• Gently pull the ribbon cable out of the ZIF connector.
• Lift the AMP Board gently while sliding the ribbon cable out through the center hole to reveal another set of wires underneath the board.

Use a spudger to flip up the small flap on the ZIF connector.

Gently pull the ribbon cable out of the ZIF connector.

Lift the AMP Board gently while sliding the ribbon cable out through the center hole to reveal another set of wires underneath the board.

Step 3

• Use a spudger to lift up one of the small flaps on only one side of the female connector.
• Pull on the wire toward the lifted side until the male connector is disconnected.
• Remove the AMP Board.

Use a spudger to lift up one of the small flaps on only one side of the female connector.

Pull on the wire toward the lifted side until the male connector is disconnected.

Remove the AMP Board.

Step 4

              Subwoofer (speaker)               

• Remove the four 30.0 mm T8 Torx screws in the corners.
• Remove the large plastic piece on top of the subwoofer while threading the ribbon cable and male connector through the hole.

Remove the four 30.0 mm T8 Torx screws in the corners.

Remove the large plastic piece on top of the subwoofer while threading the ribbon cable and male connector through the hole.

Step 5

• Remove the lid on top of the subwoofer.
• Flip the device over and let the subwoofer fall into your hand.
• The subwoofer is a strong magnet. Keep it away from any other electronics and unshielded wires.

Remove the lid on top of the subwoofer.

Flip the device over and let the subwoofer fall into your hand.

The subwoofer is a strong magnet. Keep it away from any other electronics and unshielded wires.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 2 other contributors 

                    Eric Inman                     

Member since: 10/08/2018

301 Reputation

                                      3 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges                           

Team

                       Cal Poly, Team S4-G4, White Fall 2018                        

                                                  Member of Cal Poly, Team S4-G4, White Fall 2018 



                    CPSU-WHITE-F18S4G4                     


                                            3 Members                     


                                            5 Guides authored