Difficulty
Moderate
Steps
7
Time Required
15 minutes
Sections
1
- LED/Speaker Board and Microphone
- 7 steps
Flags
0
- History
- Save to Favorites
- Download PDF
- Edit
- Translate
- Get Shareable Link
- Embed This Guide
- Notify Me of Changes
- Stop Notifications
Introduction
What you need
Step 1
LED/Speaker Board and Microphone
- Power off and unplug the echo
- Using the plastic opening tool, peel off the rubber layer on the bottom of the echo.
Power off and unplug the echo
Using the plastic opening tool, peel off the rubber layer on the bottom of the echo.
1024
Step 2
- Use the T8 screwdriver bit to unscrew the four 1.6mm torx screws
- Remove the black cylindrical base
Use the T8 screwdriver bit to unscrew the four 1.6mm torx screws
Remove the black cylindrical base
Step 3
- Use the metal spudger to lift the ZIF connector
- Remove the ribbon cable from the slot
Use the metal spudger to lift the ZIF connector
Remove the ribbon cable from the slot
Step 4
- Remove the motherboard
Remove the motherboard
Step 5
- Remove the silver divider
- Remove black rubber divider
- Remove the plastic white frame
Remove the silver divider
Remove black rubber divider
Remove the plastic white frame
Step 6
- Use the metal spudger to lift the ZIF connector
- Remove the ribbon cable from the slot on the LED/speaker board
Remove the ribbon cable from the slot on the LED/speaker board
Step 7
- Remove the LED/speaker board
Remove the LED/speaker board
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
3 other people completed this guide.
Author
with 2 other contributors
Cassidy O'Connor
Member since: 10/09/2017
408 Reputation
2 Guides authored
Badges:
10
+7 more badges
Team
USF Tampa, Team S1-G3, Leahy Fall 2017
Member of USF Tampa, Team S1-G3, Leahy Fall 2017
USFT-LEAHY-F17S1G3
3 Members
11 Guides authored
George hanes - Apr 1, 2018
Reply
I can’t seem to find the board anywhere. Where would you buy one?
