Amazon Echo Show 2Nd Gen Motherboard Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          30 minutes

Sections

Sound foam
2 steps
Motherboard
3 steps

Flags

History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Step 1

              Sound foam

Make sure the device is unplugged and powered off.
Turn the two screw plugs counterclockwise with a metal spudger until they are 90 degrees from their original position.
Pull each of the plugs out.

Make sure the device is unplugged and powered off.

Turn the two screw plugs counterclockwise with a metal spudger until they are 90 degrees from their original position.

Pull each of the plugs out.

1024

Step 2

Use the metal spudger to pry and create space between the sound foam and the frame.
Once you have sufficiently pried the foam from the frame on each side, detach the sound foam from the frame with your hands.

Use the metal spudger to pry and create space between the sound foam and the frame.

Once you have sufficiently pried the foam from the frame on each side, detach the sound foam from the frame with your hands.

Step 3

              Motherboard

Firmly grasp the white trim of the front piece with one hand while the other pulls back on the black back portion of the device.
The front and back pieces should now be separated as shown in the second picture.

Firmly grasp the white trim of the front piece with one hand while the other pulls back on the black back portion of the device.

The front and back pieces should now be separated as shown in the second picture.

Step 4

Remove all the 4mm length screws in the indicated areas using a TR6 torque screwdriver.
To reveal the motherboard of the device, gently pry off the metal plate away from the rest of the device.

Remove all the 4mm length screws in the indicated areas using a TR6 torque screwdriver.

To reveal the motherboard of the device, gently pry off the metal plate away from the rest of the device.

Step 5

Remove all 8 of the 4 mm screws from the indicated areas using the TR6 screwdriver.
Using your hands, gently detach the connected areas from the motherboard. To do so, simply pry the adhesives off with your fingers.
Carefully detach the adhesive. Make sure the wire attached to the adhesive stays attached when removing the motherboard. To do so, gently hold the wire in place.

Remove all 8 of the 4 mm screws from the indicated areas using the TR6 screwdriver.

Using your hands, gently detach the connected areas from the motherboard. To do so, simply pry the adhesives off with your fingers.

Carefully detach the adhesive. Make sure the wire attached to the adhesive stays attached when removing the motherboard. To do so, gently hold the wire in place.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors

                    Cameron Carter

Member since: 01/23/2020

211 Reputation

                                      2 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       Embry-Riddle Aeronautical University, Team S3-G2, Watkins Spring 2020                        

                                                  Member of Embry-Riddle Aeronautical University, Team S3-G2, Watkins Spring 2020 



                    ERAU-WATKINS-S20S3G2                     


                                            4 Members                     


                                            5 Guides authored

Team#

Team