Difficulty

Easy

Steps

6

Time Required

                          7 minutes

Sections

2

  • Sound foam
  • 2 steps
  • Sound Card
  • 4 steps

Flags

0

  • History
  • Save to Favorites
  • Download PDF
  • Edit
  • Translate
  • Get Shareable Link
  • Embed This Guide
  • Notify Me of Changes
  • Stop Notifications

Introduction

What you need

Step 1

              Sound foam
  • Make sure the device is unplugged and powered off.
  • Turn the two screw plugs counterclockwise with a metal spudger until they are 90 degrees from their original position.
  • Pull each of the plugs out.

Make sure the device is unplugged and powered off.

Turn the two screw plugs counterclockwise with a metal spudger until they are 90 degrees from their original position.

Pull each of the plugs out.

1024

Step 2

  • Use the metal spudger to pry and create space between the sound foam and the frame.
  • Once you have sufficiently pried the foam from the frame on each side, detach the sound foam from the frame with your hands.

Use the metal spudger to pry and create space between the sound foam and the frame.

Once you have sufficiently pried the foam from the frame on each side, detach the sound foam from the frame with your hands.

Step 3

              Sound Card
  • Unscrew the white case using the TR1 screwdriver bit to remove the 4mm screws.
  • Pull on the top until the case becomes fully dislodged.

Unscrew the white case using the TR1 screwdriver bit to remove the 4mm screws.

Pull on the top until the case becomes fully dislodged.

Step 4

  • Pull out the two white plugs by firmly grasping them and pulling in a downward motion until they become disconnected.

Pull out the two white plugs by firmly grasping them and pulling in a downward motion until they become disconnected.

Step 5

  • Unscrew the 4mm, red-marked screws with the TR6 screwdriver bit.
  • Detach the ribbon from the circuit board by grasping from the top of the ribbon and pulling away from the board.

Unscrew the 4mm, red-marked screws with the TR6 screwdriver bit.

Detach the ribbon from the circuit board by grasping from the top of the ribbon and pulling away from the board.

Step 6

  • Unscrew the red-marked, 4mm screws with the J1 screwdriver bit.
  • Carefully slide the sound card up and out of the black casing.

Unscrew the red-marked, 4mm screws with the J1 screwdriver bit.

Carefully slide the sound card up and out of the black casing.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Schyler Sapinski

Member since: 01/13/2020

329 Reputation

                                      2 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Embry-Riddle Aeronautical University, Team S3-G2, Watkins Spring 2020                        

                                                  Member of Embry-Riddle Aeronautical University, Team S3-G2, Watkins Spring 2020 



                    ERAU-WATKINS-S20S3G2                     


                                            4 Members                     


                                            5 Guides authored