Difficulty

Moderate

Steps

8

Time Required

                          1 hour

Sections

2

  • Sound Card
  • 4 steps
  • Speakers
  • 4 steps

Flags

0

  • History
  • Save to Favorites
  • Download PDF
  • Edit
  • Translate
  • Get Shareable Link
  • Embed This Guide
  • Notify Me of Changes
  • Stop Notifications

Introduction

What you need

Step 1

              Sound Card
  • Unscrew the white case using the TR1 screwdriver bit to remove the 4mm screws.
  • Pull on the top until the case becomes fully dislodged.

Unscrew the white case using the TR1 screwdriver bit to remove the 4mm screws.

Pull on the top until the case becomes fully dislodged.

1024

Step 2

  • Pull out the two white plugs by firmly grasping them and pulling in a downward motion until they become disconnected.

Pull out the two white plugs by firmly grasping them and pulling in a downward motion until they become disconnected.

Step 3

  • Unscrew the 4mm, red-marked screws with the TR6 screwdriver bit.
  • Detach the ribbon from the circuit board by grasping from the top of the ribbon and pulling away from the board.

Unscrew the 4mm, red-marked screws with the TR6 screwdriver bit.

Detach the ribbon from the circuit board by grasping from the top of the ribbon and pulling away from the board.

Step 4

  • Unscrew the red-marked, 4mm screws with the J1 screwdriver bit.
  • Carefully slide the sound card up and out of the black casing.

Unscrew the red-marked, 4mm screws with the J1 screwdriver bit.

Carefully slide the sound card up and out of the black casing.

Step 5

              Speakers
  • Firmly grasp the white trim of the front piece with one hand while the other pulls back on the black back portion of the device.

Firmly grasp the white trim of the front piece with one hand while the other pulls back on the black back portion of the device.

Step 6

  • Unscrew all the indicated screws with the screwdriver.
  • Carefully remove the plate from the device.

Unscrew all the indicated screws with the screwdriver.

Carefully remove the plate from the device.

Step 7

  • After unscrewing the speakers, gently pull out the foam covered attachment indicated in the orange box.

After unscrewing the speakers, gently pull out the foam covered attachment indicated in the orange box.

Step 8

  • Insert the white circuit box into the back plate the old speaker was removed from as indicated in he orange box.
  • Repeat on the other speaker if needed.

Insert the white circuit box into the back plate the old speaker was removed from as indicated in he orange box.

Repeat on the other speaker if needed.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Cameron Carter

Member since: 01/23/2020

211 Reputation

                                      2 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       Embry-Riddle Aeronautical University, Team S3-G2, Watkins Spring 2020                        

                                                  Member of Embry-Riddle Aeronautical University, Team S3-G2, Watkins Spring 2020 



                    ERAU-WATKINS-S20S3G2                     


                                            4 Members                     


                                            5 Guides authored