Difficulty
Moderate
Steps
4
Time Required
10 - 15 minutes
Sections
1
Flags
0
- History
- Save to Favorites
- Download PDF
- Edit
- Translate
- Get Shareable Link
- Embed This Guide
- Notify Me of Changes
- Stop Notifications
Introduction
What you need
Use a spudger to remove the grey bottom cover.
During reassembly, adhesive needs to be applied to secure the bottom cover.
1024
Step 2
- Remove the three screws with a T6 Torx screwdriver.
Remove the three screws with a T6 Torx screwdriver.
Step 3
- Use a spudger to release the six internal tabs lining the sides of the device.
- There are fragile ribbon connectors along the side of the screen with the camera on it. So, do not stick the spudger more than a couple millimeters into the device.
Use a spudger to release the six internal tabs lining the sides of the device.
There are fragile ribbon connectors along the side of the screen with the camera on it. So, do not stick the spudger more than a couple millimeters into the device.
Step 4
- Carefully open the device by folding it open along the top edge where the camera is located.
- Do not try to open the device from any other side as this would damage the ribbon connectors.
Carefully open the device by folding it open along the top edge where the camera is located.
Do not try to open the device from any other side as this would damage the ribbon connectors.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Zachary Buckler
Member since: 10/26/2022
339 Reputation
3 Guides authored
Badges:
5
+2 more badges
Team
UMass Dartmouth, Team 2-4, Petersen Fall 2022
Member of UMass Dartmouth, Team 2-4, Petersen Fall 2022
UMASSD-PETERSEN-F22S2G4
3 Members
7 Guides authored
