Difficulty

Easy

Steps

5

Time Required

                          10 minutes

Sections

1

  • Camera
  • 5 steps

Flags

0

  • History
  • Save to Favorites
  • Download PDF
  • Edit
  • Translate
  • Get Shareable Link
  • Embed This Guide
  • Notify Me of Changes
  • Stop Notifications

Introduction

What you need

Step 1

              Camera
  • Use the plastic opening tool to gently lift the plastic protector from the screen.

Use the plastic opening tool to gently lift the plastic protector from the screen.

1024

Step 2

  • After the protector has been removed, use your hands to gently remove the taped-in rubber foot from device.

After the protector has been removed, use your hands to gently remove the taped-in rubber foot from device.

Step 3

  • Carefully peel off the bottom pad to expose the fastening screws.
  • Remove three silver 1.4 T5 Torx screws on the top row.
  • Remove one green 1mm T5 Torx screw in the middle.
  • Remove a black 1.5mm T5 screw.
  • Remove three green 1mm T5 screws from the bottom row.

Carefully peel off the bottom pad to expose the fastening screws.

Remove three silver 1.4 T5 Torx screws on the top row.

Remove one green 1mm T5 Torx screw in the middle.

Remove a black 1.5mm T5 screw.

Remove three green 1mm T5 screws from the bottom row.

Step 4

  • After the screws are removed, grip the front panel and separate the front from the back. This will expose the inside of the device.
  • Make sure to ground yourself against a metal object nearby (ex. a metal chair, a door frame) before you touch any circuitry. An accidental static discharge can permanently damage a circuitboard.
  • Use tweezers or your hands to carefully disconnect the red wires connecting the speakers to the power supply board.
  • Lay the front section flat, with the screen down.

After the screws are removed, grip the front panel and separate the front from the back. This will expose the inside of the device.

Make sure to ground yourself against a metal object nearby (ex. a metal chair, a door frame) before you touch any circuitry. An accidental static discharge can permanently damage a circuitboard.

Use tweezers or your hands to carefully disconnect the red wires connecting the speakers to the power supply board.

Lay the front section flat, with the screen down.

Step 5

  • Remove two 1mm T5 Torx screws.
  • Once the screws have been removed, you can easily remove the camera from the device.

Remove two 1mm T5 Torx screws.

Once the screws have been removed, you can easily remove the camera from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Christina Simone

Member since: 10/24/2018

561 Reputation

                                      4 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       University of South Florida St. Petersburg, Team S1-G3, Stowe Fall 2018                        

                                                  Member of University of South Florida St. Petersburg, Team S1-G3, Stowe Fall 2018 



                    USFSP-STOWE-F18S1G3                     


                                            4 Members                     


                                            6 Guides authored