Difficulty
Moderate
Steps
4
Time Required
10 - 15 minutes
Sections
1
- Power Supply Board
- 4 steps
Flags
0
- History
- Save to Favorites
- Download PDF
- Edit
- Translate
- Get Shareable Link
- Embed This Guide
- Notify Me of Changes
- Stop Notifications
Introduction
What you need
Step 1
Power Supply Board
- Flip the device upside down.
- Pry up the edge of the rubber base panel with a spudger, then pull the rest of it off by hand.
Flip the device upside down.
Pry up the edge of the rubber base panel with a spudger, then pull the rest of it off by hand.
1024
Step 2
- Use a T15 Torx screwdriver to remove the ten 3.2 mm screws.
- Use a Torx T10 screwdriver to remove the six 2.7 mm screws.
- After removing the screws, gently lift the base off, with care not to damage any of the connected cables.
Use a T15 Torx screwdriver to remove the ten 3.2 mm screws.
Use a Torx T10 screwdriver to remove the six 2.7 mm screws.
After removing the screws, gently lift the base off, with care not to damage any of the connected cables.
Step 3
- Before fully removing the base, remove the three attached connectors.
Before fully removing the base, remove the three attached connectors.
Step 4
- Now unscrew the the single 10 mm Phillips screw.
- Remove the power supply board.
Now unscrew the the single 10 mm Phillips screw.
Remove the power supply board.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Nick Saranich
Member since: 10/24/2022
265 Reputation
2 Guides authored
Badges:
6
+3 more badges
Team
UMass Dartmouth, Team 2-6, Petersen Fall 2022
Member of UMass Dartmouth, Team 2-6, Petersen Fall 2022
UMASSD-PETERSEN-F22S2G6
4 Members
6 Guides authored
Kertalaaki - Dec 31, 2022
Reply
Thank you for this guide. It was very easy operation, but I believe problem with Echo is that its impossible to get spare parts?
My Echo Studio is in short circuit state.
