Difficulty
Moderate
Steps
5
Time Required
30 minutes - 1 hour
Sections
1
- Battery
- 5 steps
Flags
0
- History
- Save to Favorites
- Download PDF
- Edit
- Translate
- Get Shareable Link
- Embed This Guide
- Notify Me of Changes
- Stop Notifications
Introduction
What you need
Step 1
Battery
- If the display is damaged use clear packing tape to contain any glass shards.
- Make sure the entire surface of the display is covered with tape.
- Wear safety glasses to protect your eyes.
If the display is damaged use clear packing tape to contain any glass shards.
Make sure the entire surface of the display is covered with tape.
Wear safety glasses to protect your eyes.
1024
Step 2
- Power off your phone.
- Remove the SIM card from the left side of the phone by pressing the small hole and allowing it to eject using the 0.8 screwdriver head.
- Remove the two 4mm screws on the bottom of the phone using the Torx T3 screwdriver.
Power off your phone.
Remove the SIM card from the left side of the phone by pressing the small hole and allowing it to eject using the 0.8 screwdriver head.
Remove the two 4mm screws on the bottom of the phone using the Torx T3 screwdriver.
Step 3
- Press the small suction cup just above the home button.
- While lifting up on the suction cup insert an opening pick into the crevice between the screen and back casing to pry the screen off carefully.
- Carefully separate the two halves to avoid tearing the volume rocker ribbon cable.
- Using the opening tool, disconnect the volume rocker ribbon cable from the base of the phone freeing the two halves of the phone.
Press the small suction cup just above the home button.
While lifting up on the suction cup insert an opening pick into the crevice between the screen and back casing to pry the screen off carefully.
Carefully separate the two halves to avoid tearing the volume rocker ribbon cable.
Using the opening tool, disconnect the volume rocker ribbon cable from the base of the phone freeing the two halves of the phone.
Step 4
- Using the J000 screwdriver head, remove the three 3mm screws holding the bracket in place.
- Remove the silver bracket that was held into place by the three screws just removed.
Using the J000 screwdriver head, remove the three 3mm screws holding the bracket in place.
Remove the silver bracket that was held into place by the three screws just removed.
Step 5
- Disconnect the battery connection cable by using the plastic opening tool and applying light pressure upwards on the cable.
Disconnect the battery connection cable by using the plastic opening tool and applying light pressure upwards on the cable.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
19 other people completed this guide.
Author
with 7 other contributors
Lissandra Ilcyn
Member since: 10/05/2015
799 Reputation
2 Guides authored
Badges:
11
+8 more badges
Team
Cal Poly, Team 5-7, Maness Fall 2015
Member of Cal Poly, Team 5-7, Maness Fall 2015
CPSU-MANESS-F15S5G7
5 Members
10 Guides authored
Leo Henn - Jun 28, 2016
Reply
Tolle Anleitung DANKE!!
John - Mar 6, 2017
Reply
The replacement went exactly as presented. My stock battery had pull tabs to release the adhesive, making removal very easy. Thanks for a clear step-by-step guide.
Manzoor Khan - Apr 7, 2017
Reply
How to bay amazone fire fone battry in pakistan
Shiva Sai - Aug 12, 2017
Reply
where can i get fire phone battery in india
Asheesh Barna - Aug 26, 2017
Reply
where can i get fire phone battery in UAE Abu Dhabi. It’s urgent..
