Amazon Fire Phone Headphone Jack Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          3 - 5 minutes

Sections

Headphone Jack
4 steps

Flags

History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Front Panel Assembly

If the display is damaged use clear packing tape to contain any glass shards.
Make sure the entire surface of the display is covered with tape.
Wear safety glasses to protect your eyes.

If the display is damaged use clear packing tape to contain any glass shards.

Make sure the entire surface of the display is covered with tape.

Wear safety glasses to protect your eyes.

1024

Step 2

              Preparation for Opening

Power off your phone.
Remove the sim card from the left side of the phone by pressing the small hole and allowing it to eject using the 0.8 screwdriver head.
Remove the two 4mm screws on the bottom of the phone using the Torx T3 screwdriver.

Power off your phone.

Remove the sim card from the left side of the phone by pressing the small hole and allowing it to eject using the 0.8 screwdriver head.

Remove the two 4mm screws on the bottom of the phone using the Torx T3 screwdriver.

Step 3

              Manual Opening

Press the single suction cup just above the home button.
While lifting up on the suction cup place the plastic opening tool at the rim of the screen, separating the screen from the back casing.
Carefully separate the two halves to avoid tearing the volume rocker ribbon cable.
Using the opening tool, disconnect the volume rocker ribbon cable from the base of the phone, freeing the two halves.

Press the single suction cup just above the home button.

While lifting up on the suction cup place the plastic opening tool at the rim of the screen, separating the screen from the back casing.

Carefully separate the two halves to avoid tearing the volume rocker ribbon cable.

Using the opening tool, disconnect the volume rocker ribbon cable from the base of the phone, freeing the two halves.

Step 4

Remove the 1mm screw concealed in the headphone jack.
Afterwards the headphone jack will easily pop off.

Remove the 1mm screw concealed in the headphone jack.

Afterwards the headphone jack will easily pop off.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 2 other contributors

                    Savannah Moen

Member since: 10/29/2015

228 Reputation

                                      1 Guide authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       Cal Poly, Team 5-7, Maness Fall 2015                        

                                                  Member of Cal Poly, Team 5-7, Maness Fall 2015 



                    CPSU-MANESS-F15S5G7                     


                                            5 Members                     


                                            10 Guides authored

Kashif Arif - Nov 14, 2018

hello sir i need amazon fire back casing in Pakistan

Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Introduction

What you need

Team