Difficulty
Moderate
Steps
3
Time Required
10 - 15 minutes
Sections
1
- Motherboard
- 3 steps
Flags
0
- History
- Save to Favorites
- Download PDF
- Edit
- Translate
- Get Shareable Link
- Embed This Guide
- Notify Me of Changes
- Stop Notifications
Introduction
What you need
Step 1
Motherboard
- Place the plastic opening tool in the space between the rubber and the plastic case of the device.
- Apply pressure by pushing upward on the case.
- Separate the bottom square rubber piece from the case using the plastic opening tool until all clips are detached.
Place the plastic opening tool in the space between the rubber and the plastic case of the device.
Apply pressure by pushing upward on the case.
Separate the bottom square rubber piece from the case using the plastic opening tool until all clips are detached.
1024
Step 2
- Locate the ten J#00 Phillips screws and remove them.
Locate the ten J#00 Phillips screws and remove them.
Step 3
- Place your finger on the short edge of the motherboard and lift it to separate it from the plastic case.
Place your finger on the short edge of the motherboard and lift it to separate it from the plastic case.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
5 other people completed this guide.
Author
with 5 other contributors
jeffrey555
Member since: 09/01/2015
424 Reputation
2 Guides authored
Badges:
9
+6 more badges
Team
USF Tampa, Team 16-3, Wollert Fall 2015
Member of USF Tampa, Team 16-3, Wollert Fall 2015
USFT-WOLLERT-F15S16G3
4 Members
16 Guides authored
