Difficulty

Moderate

Steps

5

Time Required

                          15 - 35 minutes

Sections

2

  • Motherboard
  • 3 steps
  • Power Cord Port
  • 2 steps

Flags

0

  • History
  • Save to Favorites
  • Download PDF
  • Edit
  • Translate
  • Get Shareable Link
  • Embed This Guide
  • Notify Me of Changes
  • Stop Notifications

Introduction

What you need

Step 1

              Motherboard
  • Place the plastic opening tool in the space between the rubber and the plastic case of the device.
  • Apply pressure by pushing upward on the case.
  • Separate the bottom square rubber piece from the case using the plastic opening tool until all clips are detached.

Place the plastic opening tool in the space between the rubber and the plastic case of the device.

Apply pressure by pushing upward on the case.

Separate the bottom square rubber piece from the case using the plastic opening tool until all clips are detached.

1024

Step 2

  • Locate the ten J#00 Phillips screws and remove them.

Locate the ten J#00 Phillips screws and remove them.

Step 3

  • Place your finger on the short edge of the motherboard and lift it to separate it from the plastic case.

Place your finger on the short edge of the motherboard and lift it to separate it from the plastic case.

Step 4

              Power Cord Port
  • With the mother board back facing you locate the power cord port found on the far left end.

With the mother board back facing you locate the power cord port found on the far left end.

Step 5

  • Locate the four soldering joints for the power cord port found on the top side of the mother board.
  • Desolder the joints of the power cord port to release it from the motherboard.
  • Place the new power cord port into its original location and solder its joints.
  • Use the iFixit soldering and desoldering guide.

Locate the four soldering joints for the power cord port found on the top side of the mother board.

Desolder the joints of the power cord port to release it from the motherboard.

Place the new power cord port into its original location and solder its joints.

Use the iFixit soldering and desoldering guide.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      5 other people completed this guide.

Author

                                      with 5 other contributors 


                    jeffrey555

Member since: 09/01/2015

424 Reputation

                                      2 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       USF Tampa, Team 16-3, Wollert Fall 2015                        

                                                  Member of USF Tampa, Team 16-3, Wollert Fall 2015 



                    USFT-WOLLERT-F15S16G3                     


                                            4 Members                     


                                            16 Guides authored

wagnerjr1977 - Feb 10, 2020

Reply

Aonde compro essa fonte ? wagnerj957@gmail.com

Ola moro no Brasil minha fonte queimou aonde compro outra?