Difficulty
Easy
Steps
5
Time Required
10 minutes
Sections
2
- Front and Back Panel Disassembly
- 4 steps
- On/Off Switch
- 1 step
Flags
0
- History
- Save to Favorites
- Download PDF
- Edit
- Translate
- Get Shareable Link
- Embed This Guide
- Notify Me of Changes
- Stop Notifications
Introduction
What you need
Step 1
Front and Back Panel Disassembly
- The unit head needs to be switched to the off position and unplugged before any disassembly.
- When removing screws in the following steps, make sure the unit is resting on a flat surface because pieces will easily come apart.
- Remove seven 11 mm Phillips #1 screws from the underside of the head unit.
The unit head needs to be switched to the off position and unplugged before any disassembly.
When removing screws in the following steps, make sure the unit is resting on a flat surface because pieces will easily come apart.
Remove seven 11 mm Phillips #1 screws from the underside of the head unit.
1024
Step 2
- Upon removal of the next screws, the front panel and the shredding component attached to it will fall apart from the back panel so have the unit resting on a flat surface.
- Remove two 50 mm Phillips #1 screws from the middle of the underside of the head unit.
Upon removal of the next screws, the front panel and the shredding component attached to it will fall apart from the back panel so have the unit resting on a flat surface.
Remove two 50 mm Phillips #1 screws from the middle of the underside of the head unit.
Step 3
- Lay the back panel away from the front panel on a flat surface.
- The back panel will be light because it is only the plastic, while the front panel will be heavy with the shredding component attached to it.
Lay the back panel away from the front panel on a flat surface.
The back panel will be light because it is only the plastic, while the front panel will be heavy with the shredding component attached to it.
Step 4
- Find the green control board that is located next to the shredding motor.
- Remove two 11 mm Phillips #1 screws located on opposite sides of the control board.
- You may need to move wires over to find the screws.
Find the green control board that is located next to the shredding motor.
Remove two 11 mm Phillips #1 screws located on opposite sides of the control board.
You may need to move wires over to find the screws.
Step 5
On/Off Switch
- Pull the front panel away from the shredding unit.
- Locate the black On/Off switch attached to the front panel where the control board was once attached.
- Squeeze the wings of the On/Off switch from the inside of the front panel to detach it from its slot in the panel.
Pull the front panel away from the shredding unit.
Locate the black On/Off switch attached to the front panel where the control board was once attached.
Squeeze the wings of the On/Off switch from the inside of the front panel to detach it from its slot in the panel.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 1 other contributor
Natalie Meert
Member since: 02/11/2016
624 Reputation
4 Guides authored
Badges:
11
+8 more badges
Team
IUPUI, Team 2-4, Baechle Spring 2016
Member of IUPUI, Team 2-4, Baechle Spring 2016
IUPUI-BAECHLE-S16S2G4
4 Members
8 Guides authored
Shawn - Jul 29, 2020
Reply
Does anyone know where to buy a replacement switch?
