Difficulty

Moderate

Steps

7

Time Required

                          2 - 6 minutes

Sections

1

  • Drive Gear
  • 7 steps

Flags

0

  • History
  • Save to Favorites
  • Download PDF
  • Edit
  • Translate
  • Get Shareable Link
  • Embed This Guide
  • Notify Me of Changes
  • Stop Notifications

Introduction

What you need

Step 1

              Drive Gear
  • Remove the shredder assembly from the paper scrap bin.

Remove the shredder assembly from the paper scrap bin.

1024

Step 2

  • Remove the two 10mm PH1 screws holding the small black panel in place.

Remove the two 10mm PH1 screws holding the small black panel in place.

Step 3

  • Remove the six 14mm PH1 screws holding the bottom cover in place.
  • Remove the cover by lifting straight upwards.
  • One of the screws will be hidden beneath a warranty sticker. Simply push the head of the screwdriver through the sticker to access the screw.

Remove the six 14mm PH1 screws holding the bottom cover in place.

Remove the cover by lifting straight upwards.

One of the screws will be hidden beneath a warranty sticker. Simply push the head of the screwdriver through the sticker to access the screw.

Step 4

  • Remove the blade/motor assembly from the top cover by lifting straight upwards. Do not disconnect any wiring just yet.
  • The blades are sharp. Coming into contact with them may result in injury.

Remove the blade/motor assembly from the top cover by lifting straight upwards. Do not disconnect any wiring just yet.

The blades are sharp. Coming into contact with them may result in injury.

Step 5

  • Remove the five 8mm PH2 screws from the bracket holding the gears in place.

Remove the five 8mm PH2 screws from the bracket holding the gears in place.

Step 6

  • Use a metal spudger to pry the bracket from the main shredder assembly.
  • If the bracket is attached too tightly for the spudger, carefully use a metal screwdriver to pry it loose.

Use a metal spudger to pry the bracket from the main shredder assembly.

If the bracket is attached too tightly for the spudger, carefully use a metal screwdriver to pry it loose.

Step 7

  • Remove the two plastic drive gears from the shredder assembly by lifting straight upwards.

Remove the two plastic drive gears from the shredder assembly by lifting straight upwards.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    William Foley

Member since: 03/25/2016

548 Reputation

                                      4 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       UMass Dartmouth, Team 1-3, Miles Spring 2016                        

                                                  Member of UMass Dartmouth, Team 1-3, Miles Spring 2016 



                    UMASSD-MILES-S16S1G3                     


                                            2 Members                     


                                            4 Guides authored

opticdreams - Jul 22, 2019

Reply

Where does one buy these gear parts?