Difficulty
Difficult
Steps
9
Time Required
10 - 20 minutes
Sections
2
- Drive Gear
- 7 steps
- Motor
- 2 steps
Flags
0
- History
- Save to Favorites
- Download PDF
- Edit
- Translate
- Get Shareable Link
- Embed This Guide
- Notify Me of Changes
- Stop Notifications
Introduction
What you need
Step 1
Drive Gear
- Remove the shredder assembly from the paper scrap bin.
Remove the shredder assembly from the paper scrap bin.
1024
Step 2
- Remove the two 10mm PH1 screws holding the small black panel in place.
Remove the two 10mm PH1 screws holding the small black panel in place.
Step 3
- Remove the six 14mm PH1 screws holding the bottom cover in place.
- Remove the cover by lifting straight upwards.
- One of the screws will be hidden beneath a warranty sticker. Simply push the head of the screwdriver through the sticker to access the screw.
Remove the six 14mm PH1 screws holding the bottom cover in place.
Remove the cover by lifting straight upwards.
One of the screws will be hidden beneath a warranty sticker. Simply push the head of the screwdriver through the sticker to access the screw.
Step 4
- Remove the blade/motor assembly from the top cover by lifting straight upwards. Do not disconnect any wiring just yet.
- The blades are sharp. Coming into contact with them may result in injury.
Remove the blade/motor assembly from the top cover by lifting straight upwards. Do not disconnect any wiring just yet.
The blades are sharp. Coming into contact with them may result in injury.
Step 5
- Remove the five 8mm PH2 screws from the bracket holding the gears in place.
Remove the five 8mm PH2 screws from the bracket holding the gears in place.
Step 6
- Use a metal spudger to pry the bracket from the main shredder assembly.
- If the bracket is attached too tightly for the spudger, carefully use a metal screwdriver to pry it loose.
Use a metal spudger to pry the bracket from the main shredder assembly.
If the bracket is attached too tightly for the spudger, carefully use a metal screwdriver to pry it loose.
Step 7
- Remove the two plastic drive gears from the shredder assembly by lifting straight upwards.
Remove the two plastic drive gears from the shredder assembly by lifting straight upwards.
Step 8
Motor
- Remove the four 18mm PH2 screws holding the motor to the main shredder assembly.
Remove the four 18mm PH2 screws holding the motor to the main shredder assembly.
Step 9
- Disconnect the motor from the motherboard by either clipping the wires, or using a soldering iron to disconnect the wires directly at the board.
- To reattach the motor, solder the wires back together, or to the motherboard depending on how you removed them.
Disconnect the motor from the motherboard by either clipping the wires, or using a soldering iron to disconnect the wires directly at the board.
To reattach the motor, solder the wires back together, or to the motherboard depending on how you removed them.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
William Foley
Member since: 03/25/2016
548 Reputation
4 Guides authored
Badges:
10
+7 more badges
Team
UMass Dartmouth, Team 1-3, Miles Spring 2016
Member of UMass Dartmouth, Team 1-3, Miles Spring 2016
UMASSD-MILES-S16S1G3
2 Members
4 Guides authored
Binh - Mar 18, 2021
Reply
Do you sell motor?
