Difficulty
Easy
Steps
5
Time Required
20 minutes
Sections
1
- Motherboard
- 5 steps
Flags
Slice and Dice
The steps in this guide should be split up and made into a series of prerequisite guides.
- History
- Save to Favorites
- Download PDF
- Edit
- Translate
- Get Shareable Link
- Embed This Guide
- Notify Me of Changes
- Stop Notifications
Introduction
What you need
Step 1
Motherboard
- Hold the speaker firmly and wedge a plastic opening tool in between the faceplate and the body of the speaker.
- Move the tool back and forth along the entire perimeter of the face plate until you feel the plate loosen, then pry the plate off.
Hold the speaker firmly and wedge a plastic opening tool in between the faceplate and the body of the speaker.
Move the tool back and forth along the entire perimeter of the face plate until you feel the plate loosen, then pry the plate off.
1024
Step 2
- Using a Phillips #1 screwdriver, remove the four black 10mm screws around each of speakers.
- Using a Phillps #1 screwdriver, remove the four black 10mm screws securing the inside panel to the case.
Using a Phillips #1 screwdriver, remove the four black 10mm screws around each of speakers.
Using a Phillps #1 screwdriver, remove the four black 10mm screws securing the inside panel to the case.
Step 3
- Tilt the case downwards until the speakers fall out of their housings.
- Reach your thumb and forefinger past the speakers and detach the front speaker panel from the unit.
Tilt the case downwards until the speakers fall out of their housings.
Reach your thumb and forefinger past the speakers and detach the front speaker panel from the unit.
Step 4
- Gently pull each plastic connector from the motherboard.
- Take a note of which connector goes with each component for easy reassembly.
- Use a Phillips #1 screwdriver to remove each of the three black 9.6mm screws from the motherboard.
Gently pull each plastic connector from the motherboard.
Take a note of which connector goes with each component for easy reassembly.
Use a Phillips #1 screwdriver to remove each of the three black 9.6mm screws from the motherboard.
Step 5
- Gently pull out the two ribbon connectors to disconnect the motherboard from the case.
Gently pull out the two ribbon connectors to disconnect the motherboard from the case.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 1 other contributor
Chris Shannon
Member since: 02/01/2016
1,012 Reputation
5 Guides authored
Badges:
13
+10 more badges
Team
USF Tampa, Team 14-2, Lacy Spring 2016
Member of USF Tampa, Team 14-2, Lacy Spring 2016
USFT-LACY-S16S14G2
3 Members
5 Guides authored
