Difficulty
Difficult
Steps
4
Time Required
20 - 30 minutes
Sections
1
- Push Button
- 4 steps
Flags
0
BackAmbient Weather Observer
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Push Button
- First, unscrew the 4 M2x1.5-7 screws (7mm length) from the back of the device using a number 1 Phillips screwdriver.
- Pry the front silver panel away from the back black panel with a small plastic opening tool.
First, unscrew the 4 M2x1.5-7 screws (7mm length) from the back of the device using a number 1 Phillips screwdriver.
Pry the front silver panel away from the back black panel with a small plastic opening tool.
1024
Step 2
- Next, the ribbon cable needs to be carefully removed from the back of the LCD screen.
- Use a plastic opening tool to press the black bar towards the ribbon and away from the white bar gently. This will release the ribbon.
Next, the ribbon cable needs to be carefully removed from the back of the LCD screen.
Use a plastic opening tool to press the black bar towards the ribbon and away from the white bar gently. This will release the ribbon.
Step 3
- Heat up solder with soldering iron, and quickly use a desoldering gun to remove solder on the pins.
Heat up solder with soldering iron, and quickly use a desoldering gun to remove solder on the pins.
Step 4
- Once the button is removed place the new button down on the board.
- Apply solder with soldering iron to the pins.
Once the button is removed place the new button down on the board.
Apply solder with soldering iron to the pins.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Trevor Hansen
Member since: 11/06/2017
104 Reputation
1 Guide authored
Badges:
4
+1 more badge
Team
IUPUI, Team S1-G2, Harley Fall 2017
Member of IUPUI, Team S1-G2, Harley Fall 2017
IUPUI-HARLEY-F17S1G2
4 Members
3 Guides authored
