Difficulty
Easy
Steps
3
Time Required
1 - 5 minutes
Sections
2
- Sandpaper Disc
- 2 steps
- Driver Pad
- 1 step
Flags
0
BackAmerican Sanders EZ-Sand Orbital Sander 07163A (2012)
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
This guide shows the removal of just one pad, but the procedure for the other two pads is identical.
What you need
Step 1
Remove the sandpaper disc
- Before you begin, be sure that the sander is unplugged and powered off.
- Carefully tilt the sander back and lay it down on its side, exposing the three sanding pads on the bottom.
Before you begin, be sure that the sander is unplugged and powered off.
Carefully tilt the sander back and lay it down on its side, exposing the three sanding pads on the bottom.
1024
Step 2
- Peel the hook-and-loop sandpaper disc off of the driver assembly.
Peel the hook-and-loop sandpaper disc off of the driver assembly.
Step 3
Remove the driver pad
- Use a 3 mm hex key or driver bit to remove the six 11.9 mm-long screws securing the driver pad.
- Remove the driver pad from the sanding disc.
Use a 3 mm hex key or driver bit to remove the six 11.9 mm-long screws securing the driver pad.
Remove the driver pad from the sanding disc.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
Miles Robinson
Member since: 03/04/2019
854 Reputation
7 Guides authored
Badges:
20
+17 more badges
Team
The Home Depot
Member of The Home Depot
Community
10,914 Members
33 Guides authored
