American Sanders Ezsand Orbital Sander 07163A 2012 Interlock Assembly Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          5 - 10 minutes

Sections

Interlock Assembly
4 steps

Flags

BackAmerican Sanders EZ-Sand Orbital Sander 07163A (2012)
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Separate the handle

Before you begin, make sure the sander is turned off and unplugged.
Use a 3/16" hex key or driver bit to remove the six 23.4 mm-long screws holding the two halves of the handle enclosure together.

Before you begin, make sure the sander is turned off and unplugged.

Use a 3/16" hex key or driver bit to remove the six 23.4 mm-long screws holding the two halves of the handle enclosure together.

1024

Step 2

The rear half of the enclosure is bolted to the handle support, so the front half will be removed first.
Pull the front half of the enclosure straight away from the rear half to separate the enclosure.
If the interlock assembly comes out with the front half of the enclosure, detach it and place it back into the rear half.
Remove the front half of the handle enclosure.

The rear half of the enclosure is bolted to the handle support, so the front half will be removed first.

Pull the front half of the enclosure straight away from the rear half to separate the enclosure.

If the interlock assembly comes out with the front half of the enclosure, detach it and place it back into the rear half.

Remove the front half of the handle enclosure.

Step 3

              Unplug the interlock assembly

Pull the wires connected to the interlock assembly straight out of their connectors.
Keep track of where each wire connects on the interlock assembly.

Pull the wires connected to the interlock assembly straight out of their connectors.

Keep track of where each wire connects on the interlock assembly.

Step 4

              Remove the interlock assembly

After all wires are disconnected from the interlock assembly, remove the interlock assembly from the handle.

After all wires are disconnected from the interlock assembly, remove the interlock assembly from the handle.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                    Miles Robinson

Member since: 03/04/2019

854 Reputation

                                      7 Guides authored                  



                       Badges:
                       20







                                                        +17 more badges

Team

                       The Home Depot                        

                                                  Member of The Home Depot 



                    Community                     


                                            10,914 Members                     


                                            33 Guides authored

Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Introduction

What you need

Team