Difficulty

Moderate

Steps

7

Time Required

Suggest a time??

Sections

1

  • Outer Casing
  • 7 steps

Flags

0

  • BackHair Dryer

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Outer Casing
  • Remove the two Phillips #00 screws:
  • One Phillips 16mm screw
  • One Phillips 14 mm screw
  • All of the hair dryer’s components are held together by these two screws. Parts may quickly separate after screw removal. Tape can be used to hold everything in place.

Remove the two Phillips #00 screws:

One Phillips 16mm screw

One Phillips 14 mm screw

All of the hair dryer’s components are held together by these two screws. Parts may quickly separate after screw removal. Tape can be used to hold everything in place.

1024

Step 2

  • Remove the top portion of the handle.
  • The model information and warnings are engraved on the top portion.

Remove the top portion of the handle.

The model information and warnings are engraved on the top portion.

Step 3

  • Remove the settings switch by lifting straight up.

Remove the settings switch by lifting straight up.

Step 4

  • Remove the internal components from the rear portion of the handle.
  • Remove the switch
  • Remove the circuitboard
  • Remove the capacitor in black plastic
  • These parts are not secured to the handle by anything, but are all connected to each other by wires. They shouldn’t be difficult to remove, but remember that they will come out together.

Remove the internal components from the rear portion of the handle.

Remove the switch

Remove the circuitboard

Remove the capacitor in black plastic

These parts are not secured to the handle by anything, but are all connected to each other by wires. They shouldn’t be difficult to remove, but remember that they will come out together.

Step 5

  • Remove the sliding black cover at the top of the handle.

Remove the sliding black cover at the top of the handle.

Step 6

  • Remove the lower portion of the handle by sliding the peg out of the slot at the top of the handle.

Remove the lower portion of the handle by sliding the peg out of the slot at the top of the handle.

Step 7

  • Separate the silver front casing from the black rear vent.

Separate the silver front casing from the black rear vent.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 1 other contributor 


                    Scott Havard

Member since: 06/27/2016

48,229 Reputation

                                      33 Guides authored                  



                       Badges:
                       38







                                                        +35 more badges