Difficulty

Difficult

Steps

7

Time Required

                          10 - 20 minutes

Sections

1

  • Heating Element
  • 7 steps

Flags

0

  • BackApalus Digital Hair Straightening Brush

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Heating Element
  • Remove the seven 5mm Phillips #1 screws on the comb-side of the brush.

Remove the seven 5mm Phillips #1 screws on the comb-side of the brush.

1024

Step 2

  • Turn comb over so the bristles are facing down.
  • Remove backside of the comb and place aside.

Turn comb over so the bristles are facing down.

Remove backside of the comb and place aside.

Step 3

  • Unplug the power cord from the connector inside of the brush.

Unplug the power cord from the connector inside of the brush.

Step 4

  • Remove the circuit board and heating element from the handle.
  • This will provide easy access to the necessary components.

Remove the circuit board and heating element from the handle.

This will provide easy access to the necessary components.

Step 5

  • Remove the four 6mm Phillips #2 screws holding the heat shield onto the back side of the bristles.

Remove the four 6mm Phillips #2 screws holding the heat shield onto the back side of the bristles.

Step 6

  • There are 4 solder points of the heating element located on the LCD side of the circuit board.
  • Desolder these four connections using a soldering iron.
  • Note which wires go to each of the connection points.
  • Soldering Technique Guide

There are 4 solder points of the heating element located on the LCD side of the circuit board.

Desolder these four connections using a soldering iron.

Note which wires go to each of the connection points.

Soldering Technique Guide

Step 7

  • Solder the new heating element to the same connection points as they were removed from.

Solder the new heating element to the same connection points as they were removed from.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 5 other contributors 


                    Aaron Brysch

Member since: 11/06/2017

231 Reputation

                                      2 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       IUPUI, Team S1-G3, Harley Fall 2017                        

                                                  Member of IUPUI, Team S1-G3, Harley Fall 2017 



                    IUPUI-HARLEY-F17S1G3                     


                                            3 Members                     


                                            3 Guides authored