Apex Ap Gs918 Camera Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          5 - 10 minutes

Sections

Power/Volume Button
3 steps
Camera
2 steps

Flags

BackAPEX AP-GS918
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Power/Volume Button

To begin, locate the two 4.9mm Phillips #00 screws at the top corners of the case and remove them.

To begin, locate the two 4.9mm Phillips #00 screws at the top corners of the case and remove them.

1024

Step 2

Squeeze the plastic opening tool in between the seam where the screen joins the plastic case.
Begin separating the bottom of the case from the screen by carefully going around the whole edge of the case and slowly prying it apart.
Be careful when separating the lids because the wires holding the speaker to the motherboard are very short.

Squeeze the plastic opening tool in between the seam where the screen joins the plastic case.

Begin separating the bottom of the case from the screen by carefully going around the whole edge of the case and slowly prying it apart.

Be careful when separating the lids because the wires holding the speaker to the motherboard are very short.

Step 3

Carefully place the bottom lid next to the screen case. The power/speaker buttons should be visible at the corner of the lid. Remove the buttons with the tweezers.

Carefully place the bottom lid next to the screen case. The power/speaker buttons should be visible at the corner of the lid. Remove the buttons with the tweezers.

Step 4

              Camera

Remove the black electrical tape covering the motherboard components along with the black cloth tape covering the camera itself.
Be careful when removing the black cloth tape from the camera on the top left corner of the tablet. The tape will likely stick and pull the camera with it.

Remove the black electrical tape covering the motherboard components along with the black cloth tape covering the camera itself.

Be careful when removing the black cloth tape from the camera on the top left corner of the tablet. The tape will likely stick and pull the camera with it.

Step 5

Locate the white and gray connector that’s holding the camera in place.
Use the black nylon spudger to eject the camera from its slot by gently lifting the gray clip vertically 90°.
Once ejected, you may easily remove the camera by pulling it from its slot.

Locate the white and gray connector that’s holding the camera in place.

Use the black nylon spudger to eject the camera from its slot by gently lifting the gray clip vertically 90°.

Once ejected, you may easily remove the camera by pulling it from its slot.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors

                    Megan Lozicki

Member since: 02/19/2015

413 Reputation

                                      4 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       USF Tampa, Team 9-1, Leahy Winter 2015                        

                                                  Member of USF Tampa, Team 9-1, Leahy Winter 2015 



                    USFT-LEAHY-W15S9G1                     


                                            3 Members                     


                                            9 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team