Difficulty
Easy
Steps
3
Time Required
5 - 10 minutes
Sections
1
- Power/Volume Button
- 3 steps
Flags
0
BackAPEX AP-GS918
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Power/Volume Button
- To begin, locate the two 4.9mm Phillips #00 screws at the top corners of the case and remove them.
To begin, locate the two 4.9mm Phillips #00 screws at the top corners of the case and remove them.
1024
Step 2
- Squeeze the plastic opening tool in between the seam where the screen joins the plastic case.
- Begin separating the bottom of the case from the screen by carefully going around the whole edge of the case and slowly prying it apart.
- Be careful when separating the lids because the wires holding the speaker to the motherboard are very short.
Squeeze the plastic opening tool in between the seam where the screen joins the plastic case.
Begin separating the bottom of the case from the screen by carefully going around the whole edge of the case and slowly prying it apart.
Be careful when separating the lids because the wires holding the speaker to the motherboard are very short.
Step 3
- Carefully place the bottom lid next to the screen case. The power/speaker buttons should be visible at the corner of the lid. Remove the buttons with the tweezers.
Carefully place the bottom lid next to the screen case. The power/speaker buttons should be visible at the corner of the lid. Remove the buttons with the tweezers.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Christopher Wright
Member since: 02/19/2015
127 Reputation
1 Guide authored
Badges:
7
+4 more badges
Team
USF Tampa, Team 9-1, Leahy Winter 2015
Member of USF Tampa, Team 9-1, Leahy Winter 2015
USFT-LEAHY-W15S9G1
3 Members
9 Guides authored