Difficulty

Moderate

Steps

5

Time Required

                          5 - 10 minutes

Sections

2

  • Casing
  • 3 steps
  • Front Camera
  • 2 steps

Flags

0

  • BackApex TM772

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Casing
  • Begin by inserting the plastic opening tool into the seam between the back and front of the case and carefully pry the back from the front.

Begin by inserting the plastic opening tool into the seam between the back and front of the case and carefully pry the back from the front.

1024

Step 2

  • Moving along the seam continue to pry the case apart.
  • The internal speaker is adhered to the inside of the back casing. There are two wires that connect the speaker to the circuit board and may be damaged if care is not taken. Once open the speaker may be removed from the back casing by removing the tape holding the speaker with either tweezers or your fingers.

Moving along the seam continue to pry the case apart.

The internal speaker is adhered to the inside of the back casing. There are two wires that connect the speaker to the circuit board and may be damaged if care is not taken. Once open the speaker may be removed from the back casing by removing the tape holding the speaker with either tweezers or your fingers.

Step 3

  • The back panel should now be disconnected from the device. This provides access to the components of the device for repairing and replacing parts of the tablet.

The back panel should now be disconnected from the device. This provides access to the components of the device for repairing and replacing parts of the tablet.

Step 4

              Front Camera
  • The front camera is located at the top right as looking inside the device.
  • With tweezers or your fingers remove the tape covering the camera’s pin connector.

The front camera is located at the top right as looking inside the device.

With tweezers or your fingers remove the tape covering the camera’s pin connector.

Step 5

  • With tweezers, flip the black latch to open the pin connector and remove the cable.

With tweezers, flip the black latch to open the pin connector and remove the cable.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Doran Van Bemmel

Member since: 04/12/2017

601 Reputation

                                      6 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       Eastern Washington University, Team S2-G6, Rowley Spring 2017                        

                                                  Member of Eastern Washington University, Team S2-G6, Rowley Spring 2017 



                    EWU-ROWLEY-S17S2G6                     


                                            3 Members                     


                                            6 Guides authored