Featured

Featured Guide

Difficulty

Easy

Steps

6

Time Required

                          10 minutes

Sections

2

  • Outer Case
  • 4 steps
  • Antenna
  • 2 steps

Flags

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

This guide has been found to be exceptionally cool by the iFixit staff.

  • BackApple AirPort Extreme Model A1034

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Outer Case
  • Remove the three 14.3mm T7 Torx screws from the bottom of AirPort.

Remove the three 14.3mm T7 Torx screws from the bottom of AirPort.

1024

Step 2

  • Remove the 5.1mm Phillips screw from the bottom of the AirPort. This screw is located under the identification sticker. You will have to remove the sticker or make a hole to remove it.

Remove the 5.1mm Phillips screw from the bottom of the AirPort. This screw is located under the identification sticker. You will have to remove the sticker or make a hole to remove it.

Step 3

  • Lift the bottom and top casing straight apart and then lift metal casing straight up from the bottom plastic casing.

Lift the bottom and top casing straight apart and then lift metal casing straight up from the bottom plastic casing.

Step 4

  • Unplug the black connector on the top of the metal casing by gently pulling horizontally.

Unplug the black connector on the top of the metal casing by gently pulling horizontally.

Step 5

              Antenna
  • Remove the two 4mm phillips screws to remove antenna.

Remove the two 4mm phillips screws to remove antenna.

Step 6

  • The circuit board connected to the antenna is attached to the metal case with foam adhesive.
  • Gently peel or cut the foam holding the circuit board with a knife and remove it from the AirPort.

The circuit board connected to the antenna is attached to the metal case with foam adhesive.

Gently peel or cut the foam holding the circuit board with a knife and remove it from the AirPort.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 8 other contributors 


                    Michael Garcia

Member since: 10/12/2011

411 Reputation

                                      5 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       Cal Poly, Team 17-15, Regan Fall 2011                        

                                                  Member of Cal Poly, Team 17-15, Regan Fall 2011 



                    CPSU-REGAN-F11S17G15                     


                                            3 Members                     


                                            13 Guides authored