Difficulty
Easy
Steps
4
Time Required
5 minutes
Sections
1
- Case
- 4 steps
Flags
0
BackApple AirPort Extreme Model A1143
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Pad
- The back pad is held in with glue so use caution when removing to prevent tearing. Low heat may be used to help remove the pad.
- Slowly peel off the rubber pad on the bottom of the device. Start from one corner and peel with your fingers. Use heat if necessary until pad is completely removed.
The back pad is held in with glue so use caution when removing to prevent tearing. Low heat may be used to help remove the pad.
Slowly peel off the rubber pad on the bottom of the device. Start from one corner and peel with your fingers. Use heat if necessary until pad is completely removed.
1024
Step 2
Back Cover
- After removing the rubber pad, unscrew the five 5mm phillips #00 screws in the holes of the back cover.
After removing the rubber pad, unscrew the five 5mm phillips #00 screws in the holes of the back cover.
Step 3
- Lift up the back case from the perforated edge to remove it.
Lift up the back case from the perforated edge to remove it.
Step 4
Remove from Case
- Remove logic board and metal casing from outer case by prying from one side using a spudger.
Remove logic board and metal casing from outer case by prying from one side using a spudger.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
6 other people completed this guide.
Author
with 3 other contributors
Zak
Member since: 09/23/2014
616 Reputation
4 Guides authored
Badges:
11
+8 more badges
Team
USF Tampa, Team 12-4, Blackwell Fall 2014
Member of USF Tampa, Team 12-4, Blackwell Fall 2014
USFT-BLACKWELL-F14S12G4
5 Members
10 Guides authored