Apple Airport Extreme Model A1143 Logic Board Replacement Repair Guide

Difficulty

Easy

Steps

7

Time Required

                          1 - 2 minutes            

Sections

2

• Case
• 4 steps
• Logic Board
• 3 steps

Flags

0

• BackApple AirPort Extreme Model A1143

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Back Pad               

• The back pad is held in with glue so use caution when removing to prevent tearing. Low heat may be used to help remove the pad.
• Slowly peel off the rubber pad on the bottom of the device. Start from one corner and peel with your fingers. Use heat if necessary until pad is completely removed.

The back pad is held in with glue so use caution when removing to prevent tearing. Low heat may be used to help remove the pad.

Slowly peel off the rubber pad on the bottom of the device. Start from one corner and peel with your fingers. Use heat if necessary until pad is completely removed.

1024

Step 2

              Back Cover               

• After removing the rubber pad, unscrew the five 5mm phillips #00 screws in the holes of the back cover.

After removing the rubber pad, unscrew the five 5mm phillips #00 screws in the holes of the back cover.

Step 3

• Lift up the back case from the perforated edge to remove it.

Lift up the back case from the perforated edge to remove it.

Step 4

              Remove from Case               

• Remove logic board and metal casing from outer case by prying from one side using a spudger.

Remove logic board and metal casing from outer case by prying from one side using a spudger.

Step 5

              Detach Logic Board From Case               

• Unhook the wires connecting the logic board to the metal casing by grabbing and pulling up on each connection with tweezers.

Unhook the wires connecting the logic board to the metal casing by grabbing and pulling up on each connection with tweezers.

Step 6

              Pull Back Tabs               

• Carefully push back the three metal tabs with your fingers on the sides of metal case.

Carefully push back the three metal tabs with your fingers on the sides of metal case.

Step 7

              Remove Metal case               

• Carefully pull the metal case away from the logic board.

Carefully pull the metal case away from the logic board.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.                                             

Author

                                      with 4 other contributors 

                    Zak                     

Member since: 09/23/2014

616 Reputation

                                      4 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges                           

Team

                       USF Tampa, Team 12-4, Blackwell Fall 2014                        

                                                  Member of USF Tampa, Team 12-4, Blackwell Fall 2014 



                    USFT-BLACKWELL-F14S12G4                     


                                            5 Members                     


                                            10 Guides authored                     

Gabriel barradenguy - Jul 17, 2016

Reply

my apple a1143 wont turn on at all no light.

what can it be done?