Difficulty

Moderate

Steps

4

Time Required

                          15 minutes

Sections

3

  • Battery
  • 1 step
  • Keyboard
  • 2 steps
  • Memory
  • 1 step

Flags

2

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Missed a Step

Oops! This guide is currently missing some important steps.

  • BackApple Powerbook 5300

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Position the Powerbook towards you with the monitor closed.
  • Press the battery removal latch located on the right side of the front panel.
  • Gently slide the battery out.
  • The keyboard, front pane, and hard drive are connected to the laptop’s logic board via a ribbon cable. Lift up slowly on each component with one hand and disconnect the ribbons from their ports on the logic board.

Position the Powerbook towards you with the monitor closed.

Press the battery removal latch located on the right side of the front panel.

Gently slide the battery out.

The keyboard, front pane, and hard drive are connected to the laptop’s logic board via a ribbon cable. Lift up slowly on each component with one hand and disconnect the ribbons from their ports on the logic board.

1024

Step 2

              Keyboard
  • Turn the laptop over and remove the three T8 torx screws from the bottom panel.

Turn the laptop over and remove the three T8 torx screws from the bottom panel.

Step 3

  • Turn the laptop back over and open the monitor.
  • With the monitor facing towards you, gently pull up on the keyboard panel from the bottom.
  • With the keyboard turned over as pictured, carefully remove its ribbon cable from the connection port on the logic board. Use a spudger to lift the white plastic retainer about 1/16" to release the cable.

Turn the laptop back over and open the monitor.

With the monitor facing towards you, gently pull up on the keyboard panel from the bottom.

With the keyboard turned over as pictured, carefully remove its ribbon cable from the connection port on the logic board. Use a spudger to lift the white plastic retainer about 1/16" to release the cable.

Step 4

              Memory
  • Pull up on the large green memory chip on the left side of the laptop. It will simply lift out.

Pull up on the large green memory chip on the left side of the laptop. It will simply lift out.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 6 other contributors 


                    Scott

Member since: 04/26/2011

155 Reputation

                                      5 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       Cal Poly, Team 25-30, Garner Spring 2011                        

                                                  Member of Cal Poly, Team 25-30, Garner Spring 2011 



                    CPSU-GARNER-S11S25G30                     


                                            4 Members                     


                                            6 Guides authored