Apple Tv 4Th Generation Heatsink Emi Shield Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          10 minutes

Sections

Heatsink/EMI Shield
2 steps

Flags

BackApple TV 4th Generation
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Remove the Heatsink

Unplug all cables from the Apple TV before disassembly and flip the device over.
Using the widest plastic opening tool, force its sharp end into the seam between the Apple TV’s bottom plate and its outer casing. Starting on the side with the ports, insert the tool so its tip is angled upward when leverage is applied.
Pry the bottom plate away from the case, starting with the edge closest to the bottom of the apple. Work your way around the plate until all clips are disconnected.
With the plastic clips free, lift the bottom plate.
The bottom plate is held in place by plastic clips that correspond to indentations on the bottom plate. These indentations break easily, as evidenced by the third photo (breakage will not prevent the plate from going back on). To avoid breakage, apply force at the location of these clips, starting from the middle.

Unplug all cables from the Apple TV before disassembly and flip the device over.

Using the widest plastic opening tool, force its sharp end into the seam between the Apple TV’s bottom plate and its outer casing. Starting on the side with the ports, insert the tool so its tip is angled upward when leverage is applied.

Pry the bottom plate away from the case, starting with the edge closest to the bottom of the apple. Work your way around the plate until all clips are disconnected.

With the plastic clips free, lift the bottom plate.

The bottom plate is held in place by plastic clips that correspond to indentations on the bottom plate. These indentations break easily, as evidenced by the third photo (breakage will not prevent the plate from going back on). To avoid breakage, apply force at the location of these clips, starting from the middle.

1024

Step 2

              Removing the Cap

Remove the five (5) 7mm T7 Torx screws.
Pull upward on the edges of the shield.
Avoid disturbing the square of gray thermal paste centered on the opposite side of the heatsink/EMI shield during removal.

Remove the five (5) 7mm T7 Torx screws.

Pull upward on the edges of the shield.

Avoid disturbing the square of gray thermal paste centered on the opposite side of the heatsink/EMI shield during removal.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 5 other contributors

                    Lisa Kelley

Member since: 10/26/2017

347 Reputation

                                      2 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       University of Maine, Team S1-G1, Diaz Fall 2017                        

                                                  Member of University of Maine, Team S1-G1, Diaz Fall 2017 



                    UMAINE-DIAZ-F17S1G1                     


                                            4 Members                     


                                            3 Guides authored

Introduction#

What you need#

#

#

#

#

Team#

#

Introduction

What you need

Team