Aps Tech 101629 Channel Switch Replacement Repair Guide

Difficulty

Moderate

Steps

7

Time Required

                          15 minutes            

Sections

2

• External Casing
• 5 steps
• Channel Switch
• 2 steps

Flags

0

• BackAPS Tech 101629

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

First the external casing will need to be removed.

What you need

Step 1

              External Casing               

• Pry all four of the plastic feet off the bottom of the enclosure using the iPod opening tool.

Pry all four of the plastic feet off the bottom of the enclosure using the iPod opening tool.

1024

Step 2

• Unscrew the four screws previously covered by the feet with a Phillips #1 screwdriver.

Unscrew the four screws previously covered by the feet with a Phillips #1 screwdriver.

Step 3

• Flip the device right side up.
• Gently slide the casing upwards and off the hard drive.

Flip the device right side up.

Gently slide the casing upwards and off the hard drive.

Step 4

• Flip device upside down again.
• Gently pry the bottom gray casing away from the device.

Flip device upside down again.

Gently pry the bottom gray casing away from the device.

Step 5

• Rotate so the back of the device is facing you.
• Gently pry the back casing away.
• When the back casing is removed, the fan will become loose.

Rotate so the back of the device is facing you.

Gently pry the back casing away.

When the back casing is removed, the fan will become loose.

Step 6

              Channel Switch               

• Find the conjoined ID cable wires that are colored black, orange, and yellow.
• Lift white portion of cable wires to disconnect it.

Find the conjoined ID cable wires that are colored black, orange, and yellow.

Lift white portion of cable wires to disconnect it.

Step 7

• At this point, the fan is loose and can be easily moved but not disconnected.
• Using the spudger, depress the pressure holders at all four corners of the fan.
• Take out the fan and its cords, by pulling it outward from its cavity within the device.

At this point, the fan is loose and can be easily moved but not disconnected.

Using the spudger, depress the pressure holders at all four corners of the fan.

Take out the fan and its cords, by pulling it outward from its cavity within the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 9 other contributors 

                    Alexis Weckel                     

Member since: 04/11/2011

140 Reputation

                                      3 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges                           

Team

                       Cal Poly, Team 24-60, Amido Spring 2011                        

                                                  Member of Cal Poly, Team 24-60, Amido Spring 2011 



                    CPSU-AMIDO-S11S24G60                     


                                            5 Members                     


                                            6 Guides authored