Aquaris M5 Battery Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          10 - 20 minutes

Sections

Back Cover
3 steps
Battery
3 steps

Flags

BackAquaris M5
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Back Cover

Insert the tip of an iFixit opening tool between the back cover and the mid frame of the phone.
Between the 2 SIM card slots is a good place to start.
Slide the opening tool to the bottom of the phone, to snap out the plastic clips, connecting the back cover and mid frame.

Insert the tip of an iFixit opening tool between the back cover and the mid frame of the phone.

Between the 2 SIM card slots is a good place to start.

Slide the opening tool to the bottom of the phone, to snap out the plastic clips, connecting the back cover and mid frame.

1024

Step 2

Slide the opening tool back to the top of the phone, to disconnect all the clips on the edge.
Slide around the corner and along the top edge, to also disconnect these clips.

Slide the opening tool back to the top of the phone, to disconnect all the clips on the edge.

Slide around the corner and along the top edge, to also disconnect these clips.

Step 3

Be careful not to bend the back cover too hard to prevent some of the clips breaking.
Grab the back cover by the loosened edge.
Gently bend and twist the flexible back cover a bit to disconnect the remaining clips.
Take off the back cover.

Be careful not to bend the back cover too hard to prevent some of the clips breaking.

Grab the back cover by the loosened edge.

Gently bend and twist the flexible back cover a bit to disconnect the remaining clips.

Take off the back cover.

Step 4

              Battery

Damaging the liquid indicator sticker, on the middle most screw, will void the warranty of the phone.
Unscrew the ten black 4mm Phillips #00 Screws from the mainboard shield.
Unscrew the golden 3.4mm Phillips #00 screw on the middle-right side of the mainboard shield.

Damaging the liquid indicator sticker, on the middle most screw, will void the warranty of the phone.

Unscrew the ten black 4mm Phillips #00 Screws from the mainboard shield.

Unscrew the golden 3.4mm Phillips #00 screw on the middle-right side of the mainboard shield.

Step 5

Insert the flat side of a spudger between the mainboard shield and the frame of the phone.
Twist the spudger to lift up the mainboard shield.
Remove the mainboard shield from the phone.

Insert the flat side of a spudger between the mainboard shield and the frame of the phone.

Twist the spudger to lift up the mainboard shield.

Remove the mainboard shield from the phone.

Step 6

Use a spudger to disconnect the battery’s flex cable from the mainboard.
Pull of the sticker on the bottom side of the battery.
Grab the sticker and lift it up to take the battery out of the phone.

Use a spudger to disconnect the battery’s flex cable from the mainboard.

Pull of the sticker on the bottom side of the battery.

Grab the sticker and lift it up to take the battery out of the phone.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      12 other people completed this guide.

Author

                                      with 2 other contributors

                    Theo Mat

Member since: 11/12/2017

12,412 Reputation

                                      14 Guides authored                  



                       Badges:
                       24







                                                        +21 more badges

Paul Flaherty - Sep 18, 2018

Very nice guide. I had seen videos on YouTube, however not one of them made it clear that one of the screws is different and therefore should be kept apart. Whereas in this guide, that fact is extremely clear. So thank you. And keep up the good work.

Stefan Hoenig - May 26, 2019

Mit ein paar Bildern besser erklärt als manches Video was im WWW es versucht… danke.

cordula.germany - Jul 2, 2019

Super Dankeschön. Habe es auf Anhieb hin bekommen .super erklärt

Ernst Michel - Dec 30, 2020

Prima Job! Mit dieser Anleitung habe ich alles in den Griff bekommen!Danke :-)

Introduction#

What you need#

Introduction

What you need