Archos 97 Carbon Motherboard Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          45 minutes - 1 hour

Sections

mother board
6 steps

Flags

BackArchos 97 Carbon
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              mother board

With the tablet facing you pry open the tablet. Start over in the left corner (by the buttons) working clockwise until the tablet is open using either a set of opening picks or a plastic pry tool.

With the tablet facing you pry open the tablet. Start over in the left corner (by the buttons) working clockwise until the tablet is open using either a set of opening picks or a plastic pry tool.

1024

Step 2

Once the screen is separated from the back panel, there will be two cables connecting the screen to the interior of the tablet (one silver, one black).
Start with the black cable that is connected to the white tab. Remove the black tape that is holding the end of the cable to the tab.
Then gently pull the cable away from the tab with tweezers, disconnecting the plug from the outlet.

Once the screen is separated from the back panel, there will be two cables connecting the screen to the interior of the tablet (one silver, one black).

Start with the black cable that is connected to the white tab. Remove the black tape that is holding the end of the cable to the tab.

Then gently pull the cable away from the tab with tweezers, disconnecting the plug from the outlet.

Step 3

Now remove the silver cable by removing the tape connecting the cable and screen, then gently detaching the gold cable from the outlet.

Now remove the silver cable by removing the tape connecting the cable and screen, then gently detaching the gold cable from the outlet.

Step 4

Now the interior of the tablet is fully accessible.
Heat up the soldering iron and once fully heated put the tip of the soldering iron on the connection terminals on the motherboard. Once the solder melts the cables and be easily pulled away.
With soldering iron also disconnect the four speaker cables on the right side of the motherboard. Put the tip of the soldering iron on each connection, melting the solder so the wires can be removed.

Now the interior of the tablet is fully accessible.

Heat up the soldering iron and once fully heated put the tip of the soldering iron on the connection terminals on the motherboard. Once the solder melts the cables and be easily pulled away.

With soldering iron also disconnect the four speaker cables on the right side of the motherboard. Put the tip of the soldering iron on each connection, melting the solder so the wires can be removed.

Step 5

Using a Philips #00 screwdriver, unscrew the 3 screws that connects the motherboard to the tablet.

Using a Philips #00 screwdriver, unscrew the 3 screws that connects the motherboard to the tablet.

Step 6

When the motherboard is completely unscrewed, flip it over so you can see the underside.
Using tweezers, gently press the sides of the black plug and pull away until the cable is detached.
Remove the other cable connector by gently pressing on the sides of the plug and pulling away until it is detached as well.

When the motherboard is completely unscrewed, flip it over so you can see the underside.

Using tweezers, gently press the sides of the black plug and pull away until the cable is detached.

Remove the other cable connector by gently pressing on the sides of the plug and pulling away until it is detached as well.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 4 other contributors

                    Sam Nance

Member since: 03/03/2015

207 Reputation

                                      1 Guide authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       Sam Houston State, Team 13-5, Blackburne Winter 2015                        

                                                  Member of Sam Houston State, Team 13-5, Blackburne Winter 2015 



                    SHSU-BLACKBURNE-W15S13G5                     


                                            3 Members                     


                                            8 Guides authored

Joel13 - Jul 19, 2015

Good morning

Do you know where i can buy an other mother board?

Because i can found any supplier to buy one.

thank in advance

Best Regard

Joël

Introduction#

What you need#

Team#

Introduction

What you need

Team