Difficulty

Easy

Steps

10

Time Required

                          15 minutes

Sections

2

  • Lower Motor Housing
  • 4 steps
  • Switch
  • 6 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackArmorAll AA255

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Lower Motor Housing
  • Remove the orange main housing unit from the vacuum bucket by pulling outward on the handle tabs while lifting upward as shown.

Remove the orange main housing unit from the vacuum bucket by pulling outward on the handle tabs while lifting upward as shown.

1024

Step 2

  • Remove the five 15mm PH2 screws.

Remove the five 15mm PH2 screws.

Step 3

  • Remove the 15 mm T20 screw. This screw is located nearest the power cord.

Remove the 15 mm T20 screw. This screw is located nearest the power cord.

Step 4

  • Gently separate the upper and lower sections of the main housing.

Gently separate the upper and lower sections of the main housing.

Step 5

              Switch
  • Using a PH2 screw head, unscrew the two 15mm screws as shown.

Using a PH2 screw head, unscrew the two 15mm screws as shown.

Step 6

  • Pull the black handle.
  • Using a PH2 screwdriver, unscrew the single 12mm screw shown.

Pull the black handle.

Using a PH2 screwdriver, unscrew the single 12mm screw shown.

Step 7

  • Use the blue opening tool to open up the black handle.

Use the blue opening tool to open up the black handle.

Step 8

  • Using your fingers, gently take out the black cords.
  • Careful to not break the black cords.

Using your fingers, gently take out the black cords.

Careful to not break the black cords.

Step 9

  • Using the spudger, take out the switch. Do this by pushing the spudger against the switch on both sides as shown and then pull the switch out.

Using the spudger, take out the switch. Do this by pushing the spudger against the switch on both sides as shown and then pull the switch out.

Step 10

  • Replace the switch shown.

Replace the switch shown.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 2 other contributors 


                    Renzo La Rosa

Member since: 02/09/2016

212 Reputation

                                      1 Guide authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       IUPUI, Team 2-1, Baechle Spring 2016                        

                                                  Member of IUPUI, Team 2-1, Baechle Spring 2016 



                    IUPUI-BAECHLE-S16S2G1                     


                                            4 Members                     


                                            4 Guides authored