Difficulty

Easy

Steps

6

Time Required

                          5 - 10 minutes

Sections

2

  • Rear Cover
  • 3 steps
  • Rubber Feet
  • 3 steps

Flags

1

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

  • BackArnova 7K G3

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Rear Cover
  • Remove four 5 mm Phillips #00 screws from each corner of the tablet.

Remove four 5 mm Phillips #00 screws from each corner of the tablet.

1024

Step 2

  • Place the iFixit opening tool in the notches between the cases and pull the covers apart.

Place the iFixit opening tool in the notches between the cases and pull the covers apart.

Step 3

  • Repeat step two until 3/4 of the rear cover is unlatched.
  • Proceed to remove the rear cover by gently pulling it apart by hand.

Repeat step two until 3/4 of the rear cover is unlatched.

Proceed to remove the rear cover by gently pulling it apart by hand.

Step 4

              Rubber Feet
  • Locate the two lower bumpers on the back cover. These are the rubber feet.
  • Flip the cover over to reveal the inside.
  • Locate the two rubber tabs, there are two for each rubber foot. They are located on the inside of the cover.

Locate the two lower bumpers on the back cover. These are the rubber feet.

Flip the cover over to reveal the inside.

Locate the two rubber tabs, there are two for each rubber foot. They are located on the inside of the cover.

Step 5

  • Push the two tabs on each foot down using the pointed end of a spudger.
  • It may take some force to push in the tabs. Prying with the pointed end of the spudger and wiggling the tab free may be necessary.

Push the two tabs on each foot down using the pointed end of a spudger.

It may take some force to push in the tabs. Prying with the pointed end of the spudger and wiggling the tab free may be necessary.

Step 6

  • Flip the cover back over so you see the outside. Remove the rubber feet if they have not already fallen out.

Flip the cover back over so you see the outside. Remove the rubber feet if they have not already fallen out.

To reassemble your device, follow these instructions in reverse order with the new rubber feet.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Tyler Sigafoose

Member since: 03/19/2015

210 Reputation

                                      2 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       Michigan Tech, Team 1-2, Lauer Spring 2015                        

                                                  Member of Michigan Tech, Team 1-2, Lauer Spring 2015 



                    MTU-LAUER-S15S1G2                     


                                            2 Members                     


                                            10 Guides authored